Torin ATBD134 Tool Chest And Cabinet Instruction Manual
- June 1, 2024
- Torin
Table of Contents
Torin ATBD134 Tool Chest And Cabinet
Assembly Instructions
-
Install each caster at the bottom of the tool chest with four screws and nuts as shown in the picture.
If caster assembly fits loose, using a screwdriver. Make only slight adjustments until caster fits properly. -
Hanger Hooks fit into holes inside of the cabinet door.
-
Attach handle/cord holder to side of cabinet. Use screws washers and nuts as shown in the picture.
-
Automatic Drawer Lock: Tool chest drawers will not open until cover is lifted up. They also will not lock in if you push them in when the cover is closed. Always lift cover, then push drawers in. When the cover is closed, the drawer will automatically lock in place.
-
There are four shelf positions inside cabinet. Choose the position height you prefer and place one side of shelf in tabs with other side of shelf hold slightly lower. Raise other side of shelf to just above tabs in opposite side and push down onto tabs. Make sure all tabs are secure.
Parts List
Description | Qty | Description | Qty |
---|---|---|---|
Cross M6x12 bolt | 4 | Handle | 1 |
Spring washer6 | 16 | Flat mat6 | 16 |
M6x12 bolt | 16 | Caster | 2 |
M6 nut | 16 | Caster with brake | 2 |
Hook | 6 | Top EVA | 1 |