QUADZILLA XZILLIRAIDER XZT Electrical Connector Instruction Manual

: June 25, 2024
: QUADZILLA

Table of Contents

XZILLIRAIDER XZT Electrical Connector
Disclaimer
Warranty
Read User Manual Online (PDF format)
Download This Manual (PDF format)

POWER SETTINGS
STOCK 35 HP 70 HP
XZILLIRAIDER XZT
DODGE 98.5 – 02 CUMMINS 5.9

XZILLIRAIDER XZT Electrical Connector

Module installation:
You will need to run the wiring harness through firewall and attach your power module to the harness inside the cab of your truck. Place the module under the dash out of the way of your peddles.
Data link connection:
The Data Link connector is located in different locations based on the year of the truck.
■ 98.5-99: The Triangle shaped connector is located on the driver’s side of the engine in the wiring harness near the power stearing pump.
■ 2000-2002: The three prong flat connector is located on the top of the fuel lift pump that is located on the driver’s side of the engine directly below the map sensor.
Note: on some 2001 trucks the connector is located on the driver’s side of the engine in the wiring harness near the power stearing pump.
A plug is installed in the data link connector on the truck to resist corrosion. Remove this and install the supplied connector from your Quadzilla Power module.
Connect the MAP sensor
Disconnect the stock wiring harness at the MAP sensor located to the rear of the fuel filter housing near the top of and on the engine block. Plug the supplied MAP sensor connector into the stock engine NAP sensor and the stock engine wiring harness connector into the supplied MAP sensor connector. The MAP sensor shown in the image is for a 2001, the 1998.5-2000 and the 2002 is a different sensor but in the same location. For the 2002 you will need to use the supplied adaptors to make your connection. For the 98.5-2000 your wiring harness will have the proper connectors on it
Installating The Switch
Connect the 4 pin connector on your switch to your power module and rout the switch to your desired location.
Once installed you will have three different power levels to choose from.

Disclaimer

THIS IS A HIGH PERFORMANCE PRODUCT. USE AT YOUR OWN RISK
Do not use this product until you have carefully read the following agreement. This sets forth the terms and conditions for the use of this product. The installation of this product indicates that the BUYER has read and understands this agreement and accepts the terms and conditions.
DISCLAIMER OF LIABILITY
Quadzilla Power, LLC and its distributors, jobbers and dealers (hereafter SELLER) shall in no way be responsible for the product’s proper use and service. THE BUYER HEREBY WAIVES ALL LIABILTY CLAIMS.
The BUYER acknowledges that he/she is not relying on the SELLER’s skill or judgment to select or furnish goods suitable for any particular purpose and that there are no liabilities which extend beyond the description on the face hereof and the BUYER hereby waives all remedies or liabilities, expressed or implied arising by law or otherwise, (including without any obligations of the SELLER with respect to fitness, merchantability and consequential damages) or whether or not occasioned by the SELLER’s negligence.
The SELLER disclaims any warranty and expressly disclaims any liability for personal injury or damages. The BUYER acknowledges and agrees that the disclaimer of any liability for personal injury is a material term for this agreement and the BUYER agrees to indemnify the SELLER and to hold the SELLER harmless from any claim related to the item of the equipment purchased. Under no circumstances will the SELLER be liable for any damages or expenses by reason of use or sales of such equipment.
The SELLER assumes no liability regarding the improper installation or misapplication of its products. It is the installer’s responsibility to check for proper installation and if in doubt, contact the manufacturer.
LIMITATION OF WARRANTY
Quadzilla Power, LLC (hereafter “SELLER”) gives limited warranty as to description, quality, merchantability, fitness for any product’s purpose, productiveness, or any other matter of SELLER’s product herewith. The SELLER shall be in no way responsible for the product’s open use and service and the BUYER hereby waives all rights other than those expressly written herein. This warranty shall not be extended or varied in, except by a written instrument signed by SELLER and BUYER.
The warranty is limited to one (1) year from the date of sale and limited solely to the parts contained within the product’s kit. All products that are in question of Warranty must be returned shipping prepaid to the SELLER and must be accompanied by a dated proof of purchase receipt. All warranty claims are subject to approval by Quadzilla Power, LLCUnder no circumstances shall the SELLER be liable for any labor charged or travel time incurred in diagnosis for defects, removal, or reinstallation of this product, or any other contingent expenses.
Under no circumstances shall the SELLER be liable for any damages or expenses insured by reason of the use of sale of any such equipment.
IN THE EVENT THAT THE BUYER DOES NOT AGREE WITH THIS AGREEMENT:
THE BUYER MAY PROMPTLY RETURN THIS PRODUCT, IN A NEW AND UNUSED CONDITION WITH A DATED PROOF OF PURCHASE TO THE PLACE OF
PURCHASE WITHIN THIRTY (30) DAYS FROM THE DATE OF PURCHASE FOR A FULL REFUND.
THE INSTALLATION OF THIS PRODUCT INDICATES THAT THE BUYER HAS READ AND UNDERSTANDS THIS AGREEMENT AND ACCEPTS ITS TERMS AND CONDITIONS.

NOT CARB LEGAL: NOT FOR SALE OR USE IN CALIFORNIA OR OTHER CARB STATES.

Warranty

All QUADZILLA Performance Modules, Tuners, and units are covered by a one year unlimited mileage warranty.
WHAT IS WARRANTED:
Any Performance Modules/Tuners Diesel Performance Enhancement Software specified for and Cummins, Powerstroke, and, Duramax diesel engines, except those units sold exclusively for racing and/or off-road use.
WHO IS COVERED BY WARRANTY:
The original purchaser of a Performance Modules/Tuners who has completed the required warranty registration and provided proper proof of the original retail purchase and all other required information.
WHAT IS NOT WARRANTED:
Any Performance Modules/Tuners used for any type of racing or competition, any off-road use, custom or modified applications, any non-legal or industrial applications. (These units are covered by a one year unlimited mileage warranty for both Software and Hardware.)
WHAT VOIDS THE WARRANTY:
Incorrect Installation: The Performance Modules/Tuners must be installed following Quadzilla installation procedure as outlined in the product literature that accompanies the Performance Modules/Tuners. Physical damage to the unit due to improper care in installation or removal will not be covered under this warranty.
No Registration: Failure to register your product within 90 days of purchase will void the one year unlimited mileage warranty. No Proof of Purchase: At time of warranty claim, buyer must provide proof of purchase (original receipt or invoice).
Incorrect Use: Any damaged, abused or modified Performance Modules/Tuners will not be warranted.
EXTENT OF WARRANTY:
Any defective Performance Modules/Tuners properly returned to QUADZILLA will be replaced or repaired by QUADZILLA. QUADZILLA will not be responsible for any other expenses incurred by the customer under the terms of this warranty, nor shall it be responsible for any damages consequential, special, contingent, or otherwise; or expenses or injury arising directly or indirectly from the use of the Performance Modules/Tuners unit or software. Any Performance Modules/Tuners returned to QUADZILLA must be sent at the customer’s expense along with proof of purchase. QUADZILLA reserves the right to determine whether the terms of the warranty, set out above, have been properly complied with. In the event that the terms are not complied with, QUADZILLA shall be under no obligation to honor this warranty.
SHORTAGES AND DAMAGED GOODS:
It is the responsibility of the customer to inspect and count products upon receipt.
Any shortages or errors must be reported to Quadzilla immediately. Claims for shortages or damaged goods must be received within 3 days of receipt of the product. All merchandise is inspected before packing. Any damaged goods should be reported to the freight carrier immediately. All packaging of damaged goods must be kept for inspection by the freight carrier.
RETURNS AND EXCHANGES:
An RMA (return merchandise authorization) must accompany all returns and exchanges. Returns must include a copy of the original invoice. Returns and exchanges must be shipped pre-paid or they will be refused.
Returned or exchanged products must be undamaged, or in “like new” condition.
Damage occurred during freight due to improper packing is the responsibility of the customer. Unauthorized or refused merchandise are subject to a 10% restocking fee.