UPLIFT DESK FRMA-2-COM-CORE1 Side Bracket Instructions
- June 3, 2024
- UPLIFT DESK
Table of Contents
Side Bracket Attachment Instruction
(C-Frame and T-Frame)
Instructions
FRMA-2-COM-CORE1 Side Bracket
IMPORTANT, PLEASE READ:
If your Core 1 frame box is labeled with either of the following SKUs, you will need to use this instruction sheet for the side bracket attachment section.
- FRMA-2-COM-CORE1
- FRMA-3-COM-CORE1
If your Core 1 frame box is labeled with either of the following SKUs, you can discard this instruction sheet and use the instructions received in your Core 1 frame box.
- FRM600
- FRM650
C-Frame Feet & Side Brackets Box Components
P1
Foot
(includes Leveling Glides, qty 2)| P2
Side Bracket
(right and left, qty 2)
---|---
|
P16
Logo Plate
(qty 2)| H1
M6x10
Machine Screw (qty 4)
|
T-Frame Feet & Side Brackets Box Components
P1
Foot
(includes Leveling Glides, qty 2)| P2
Side
Bracket (qty 2)
---|---
|
P3
T-Frame Crossbar End Adapter
(right and left qty 2)| P16
LogoPlate
(qty 2)
|
H1
M6x10
Machine Screw (qty 4)| H7
M8x10
Machine Screw (qty 4)
|
Side Bracket Attachment
A. Slide the tabs of the Side Bracket (P2) into the Crossbar End (P5) and insert two Machine Screws (H1) through the top of the Crossbar Endas shown. Loosely start each screwby hand, but do not tighten themcompletely.
Side Bracket Attachment (Continued)
B. Insert two more Machine Screws (H1) through the two larger holes in the
face of the Side Bracket (P2) and into the Leg. Loosely start each screw by
hand, but do not tighten them completely.C. Once all four screws (H1) are started, tighten them
completely.
D. Attach the Logo Plate (P16) by pressing the posts on the Logo Plate firmly
into the two smaller holes in the side of the Side Bracket. The Logo Plate
conceals the two screws in the face of the Side Bracket.
When assembling the Legs in the orientation shown, the Logo Plate will need to
be attached upsidedown so that it is right-side-up when the desk is flipped
over.
F. Repeat these steps for the second Leg assembly.
40032394v.A
AI-FRM60X-1.0