ansult 004673 Ceiling Fan Instruction Manual
- June 4, 2024
- ansult
Table of Contents
004673
CEILING LAMP
OPERATING INSTRUCTIONS
Important! Read the user instructions carefully before use. Save them for
future reference. (Translation of the original instructions).
Care for the environment!
Recycle discarded products in accordance with local regulations.
Jula reserves the right to make changes. For the latest version of operating
instructions, see www.jula.com 
SAFETY INSTRUCTIONS
- Keep out of the reach of children.
- Do not connect the light to the mains while it is still in the pack.
- Check that all the electrical and connecting cables comply with local regulations and are connected in accordance with the instructions.
- Do not overload the mains. This can cause a fire or the risk of electric shock.
- Do not store the light in a damp or very cold/hot place to avoid damaging the electronics.
- The electronics in the light are sensitive to knocks and blows. Avoid dropping it.
- Never attempt to replace damaged electrical cables yourself.
- Do not use the light without the glass.
WARNING!
New installations and extensions to existing systems must always be carried
out by an authorised electrician. If you know how (otherwise contact an
electrician), you can replace switches and power points, fit plugs, extension
cords, and sockets. Incorrect installation can result in fatal injury and the
risk of fire.
Symbols
| Approved as per applicable directives.
---|---
****| Class II. Double insulation.
| Protection rating IP44.
| Recycle discarded products in accordance with local regulations.
| Warning: Risk of electric shock.
TECHNICAL DATA
| Rated voltage | 230 V ~ 50 Hz |
|---|---|
| Output | Max 60 W |
| Socket Safety class | E27 |
| Safety class | II |
| Protection rating | IP44 |
| Dimensions | Ø 24 x 12 cm |
DESCRIPTION
- Plug
- Ceiling light fixture
- Screw
- Light source
- Chimney
FIG. 1
ASSEMBLY
- Release the glass from the ceiling light.
- Mark out where the ceiling light is to be installed.
- Drill holes: Make sure not to damage any recessed cables or conduits.
- Connect the wires to the terminal block in the ceiling light.
- Fit the ceiling light with the screws.
- Replace the glass on the ceiling light.
2022-07-06
© Jula AB
JULA AB, BOX 363, SE-532 24 SKARA