Carrier 38RCD 025-060 Vibration Isolation Accessory Installation Guide

Carrier 38RCD 025-060 Vibration Isolation Accessory Installation Guide

SAFETY CONSIDERATIONS

Installation of this accessory can be hazardous due to system pressures, electrical components, and equipment location (such as a roof or elevated structure). Only trained, qualified installers and service technicians should install, start-up, and service this equipment.

When installing this accessory, observe precautions in the literature, labels attached to the equipment, and any other safety precautions that apply:

• Follow all safety codes
• Wear safety glasses and work gloves
• Use care in handling and installing this accessory

It is important to recognize safety information. This is the safety- alert symbol: . When you see this symbol on the unit and in instructions or manuals, be alert to the potential for personal injury.
Understand the signal words DANGER, WARNING, CAUTION, and NOTE. These words are used with the safety-alert symbol. DANGER identifies the most serious hazards which will result in severe personal injury or death. WARNING signifies hazards which could result in personal injury or death. CAUTION is used to identify unsafe practices, which may result in minor personal injury or product and property damage. NOTE is used to highlight suggestions which will result in enhanced installation, reliability, or operation.

GENERAL

Multiple accessory packages may be required depending on product, refer to Table 1 for accessory package selection. Each vibration isolation accessory package consists of 4 resilient neoprene pads See Table 2. The pads are oil- resistant and have a ribbed design. (See Fig. 1 and 2.)

PRE-INSTALLATION

Remove accessory from packaging and inspect shipment for damage. File claim with shipping company if accessory is damaged or incomplete.

INSTALLATION

The accessory kit is usually installed at the initial unit installation. If the kit is to be installed after the unit is already in place, disconnect all power, chilled fluid piping, and refrigerant piping to the unit first.

WARNING
Electrical shock can cause personal injury and death. Shut off all power to this equipment during installation and service. There may be more than one disconnect switch. Tag all disconnect locations to alert others not to restore power until work is completed.

Install the accessory kit as follows:

1. Rig unit per base unit installation instructions and raise unit above its final installation location (see Fig. 3-5).
2. Locate pads at mounting points as shown in Fig. 6.
3. Lower unit in place. Note that unit must be leveled according to base unit installation instructions.
4. Restore unit power and piping connections or continue with initial unit installation.

Fig. 1 — Vibration Isolation Pad Dimensions (30RC-900- – -005)

Fig. 2 — Vibration Isolation Pad Dimensions (30MP-900- – -003)

Fig. 4 — 38RC, 09RC, and 30RC Typical Installation

Fig. 3 — 30MP Typical Installation

Fig. 5 — 30MP with Height Adjustment Typical Installation

NOTE: Place pads under mounting feet.
Fig. 6 — Vibration Isolation Pad Locations

Documents / Resources

| Carrier 38RCD 025-060 Vibration Isolation Accessory [pdf] Installation Guide
38RCD 025-060, 30RCS 025-050, 09RCM 050-060, 09RCS 020-035, 30MPA 021-080, 30MPE, 30MPW 017-080, 30RC 010-060, 38RCD 025-060 Vibration Isolation Accessory, 38RCD 025-060, Vibration Isolation Accessory, Isolation Accessory, Accessory
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>