RetroSound GRAND PRIX electric Radio Face User Guide
- June 3, 2024
- RetroSound
Table of Contents
RetroSound GRAND PRIX electric Radio Face User Guide
What’s in the Box
Hardware
DIN Brackets (Included with DIN Kit 296)
Installation
Control Layout
REQUIRED FIRST STEP – GRAND PRIX MODE
The following steps must be performed to set up the Radio Motor to function with the Grand Prix Radio controls. With the vehicles ignition on and the time displayed on the Radio Face, press and hold the Power Button(1) for approximately 15 seconds to reboot the radio into SEL PANEL mode. Once SEL PANEL is displayed release the Power Button(1) and tap the Volume Paddle(6) up until GRAND PRIX is displayed on the screen. The Display will Flash GRAND PRIX 5 times and will turn off. Your Radio Motor is now configured to work with your selected face. Press the Power Button(1) to turn the Motor back on and continue with the setup process.
Radio Presets
Setting Radio Presets
To set a preset, tune to the station you want to set the preset to, and then
press and hold the mdesired Preset Button(5) for three seconds. (NOTE:
SiriusXM® does not use preset #6)
Recalling Radio Presets
To recall a preset, simply press the Preset Button(5) your station was set to
previously.
Basic Operation
-
Power On/Off
Press the Power Button(1) to power the unit on.
Press and hold the Power Button(1) to power the unit off. -
Volume
Tap the Volume Paddle(6) up or down to change the Volume. -
Changing Source Modes
Press the inner Left Arrow(8) to cycle through the source modes. -
Changing Radio Bands
Press the outer Right Arrow(9) to cycle through the radio bands. -
Tune
Tap the Auto Paddle(7) up or down to scroll through the stations. -
Mute On/Off
Press the Mute Button(4) to mute and unmute. -
Equalizer (EQ)
Press the Audio Button(2) to enter the Tone Control sub-menu. Press and release the Audio Button(2) until you see the EQ setting you’d like to adjust. Tap the Volume Paddle(6) up or down to adjust the setting and let the unit time out to set. Repeat to adjust each EQ setting. -
Setting the Clock
Press and hold the System Button(3) for three seconds to enter the System Settings submenu. Tap the Auto Paddle(7) up or down until to cycle through the choices until you see CLK, then press the System Button(3) to select. Tap the Auto Paddle(7) up or down to adjust the hours, then press the System Button(3) again to move on to minutes. Tap the Auto Paddle(7) up or down to adjust the minutes, and let the unit time out to set. -
**Display Color***
Press and hold the System Button(3) for three seconds to enter the System Settings submenu. Tap the Auto Paddle(7) up or down to cycle through the choices until you see SCAN, then press and release the System button to cycle through the color presets. Let the unit time out to set. -
Beep On/Off
Press and hold the System Button(3) for three seconds to enter the System Settings submenu. Tap the Auto Paddle(7) up or down to cycle through the choices until you see BEEP ON/ OFF, then press the System Button(3) to choose between BEEP ON or BEEP OFF. Let the unit time out to set.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>