RetroSound Monterey-Face Radio Replacement Display Face User Guide
- June 5, 2024
- RetroSound
Table of Contents
Monterey-Face Radio Replacement Display Face
User Guide
What’s in the Box
Radio
Shafts & Hardware
Additional Parts
NOTE:
Push-Buttons are packaged separately.
Installation
Insert the Push-Buttons into the Monterey Radio Face
Plug the attached wire from the Push-Buttons into the smaller receptor on the Radio Face.
Plug the ribbon cable from the Radio Motor into the Radio Face.
Complete the installation by securing the Radio Face and Push-Button assembly with the four small screws located in the small orange bag in the Radio Face box; and the two small screws located in the Push-Button box.
Control Layout
(Vintage Overlay sold separately)
Radio Presets
Setting Radio Presets
To set a preset, tune to the station you want to set the preset to, and then
press and hold the desired Preset Button(5) for two seconds.
Recalling Radio Presets
To recall a preset, simply press the Preset Button(5) your station was set to
previously.
Basic Operation
Power On/Off
Press the Left-Front Knob(1) to power the unit on.
Press and hold the Left-Front Knob(1) to power the unit off.
Volume
Rotate the Left-Front Knob(1) to change the volume.
Changing Source Modes
Rotate the Left-Rear Knob(2) clockwise to cycle through the source modes.
Changing Radio Bands
Rotate the Right-Rear Knob( 4 ) counter-clockwise to cycle through
the radio bands.
Tune
Rotate the Right-Front Knob(3) to scroll through the stations.
Mute On/Off
Press the Right-Front Knob(3) to mute and unmute.
Equalizer (EQ)
Press the Left-Front Knob(1) to enter the Tone Control sub-menu. Press and
release the Left-Front Knob(1) until you see the EQ setting you’d like to
adjust. Rotate the Left-Front Knob(1) to adjust the setting. Press the Left-
Front Knob(1) to move to the next item, and repeat to adjust each option. Let
the unit time out to set.
Setting the Clock
Press and hold the Right-Front Knob(3) to enter the System Settings sub-
menu. Rotate the Right-Front Knob(3) to cycle through the choices until you
see CLK, then press the Right-Front Knob(3) to select. Rotate the Right-Front
Knob(3) to adjust the hours. Then press the Right-Front Knob(3) again to move
on to minutes. Rotate the Right-Front Knob(3) to adjust the minutes. Let the
unit time out to set.
Display Color
Press and hold the Right-Front Knob(3) to enter the System Settings sub-
menu. Rotate the Right-Front Knob(3) to cycle through the choices until you
see SCAN, then press the Right Front Knob(3) to cycle through the colors. Let
the unit time out to set.
Beep On/Off
Press and hold the Right-Front Knob(3) to enter the System Settings sub-
menu. Rotate the Right-Front Knob(3) to cycle through the choices until you
see BEEP ON/OFF, then press the Right-Front Knob(3) to choose between BEEP ON
or BEEP OFF. Let the unit time out to set.
Modern Sound For Your Classic
[email protected] |
help.retromanufacturing.com