RetroSound SCP-05 Vintage Dial Screen Overlay Installation Guide
- June 6, 2024
- RetroSound
Table of Contents
Vintage Overlay
Installation Instructions
Install in a dust-free environment. Do not touch the application side of the
Vintage Overlay, and do not touch the radio display before or during
installation.
Step 1: Clean the radio display with a soft, lint-free cloth to remove
any oil or dirt.
Step 2: Slowly peel off the film labeled “1” from the application side of
the Vintage Overlay. Carefully apply the application side of the Vintage
Overlay to your radio display.
Step 3: Remove any air bubbles that may have formed by gently rubbing
with a credit card or lint-free cloth (be sure not to rub too hard, or you may
rub the ink off of the Vintage Overlay). If dust gets trapped beneath the
Vintage Overlay, see the reverse side of this guide for troubleshooting
instructions.
Note: These Vintage Overlays cannot completely protect your radio display
from all scratches, abrasions or from damage resulting from impacts to the
display.
Troubleshooting Instructions
Removing Dust From Beneath the Vintage Overlay
Step 1: Place a piece of adhesive tape on the corner of the Vintage Overlay
closest to the dust particle or air bubble and lift up.
Step 2: Use the second piece of adhesive tape to remove the dust particle.
Step 3: Lay the Vintage Overlay back down on the screen and remove any air
bubbles that may have formed (see reverse for instructions).
Step 4: Remove the adhesive tape.
Realigning the Vintage Overlay
Step 1: Place a piece of adhesive tape on the corner of the Vintage Overlay
and lift it up. Do not touch the radio display or the application side of the
Vintage Overlay.
Step 2: Carefully realign the edge of the Vintage Overlay with the radio
display.
Step 3: Remove any air bubbles that may have formed (see reverse for
instructions).
tech@retromanufacturing.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>