GYMSTICK TM-WPAD-PRO Treadmill Instruction Manual

GYMSTICK TM-WPAD-PRO Treadmill

WARNING

• To reduce the risk of personal injury, read and understand all the instructions before using this product.
• Electric shock hazard, where the appliance is used without the earth connection.
• Never leave the treadmill unattended. Unplug the unit from the power outlet when it is not in use.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
• This equipment is for household and office use only. Do not use the equipment outdoors.
• If you feel any chest pains, nausea, dizziness, or short of breath, you should stop exercising immediately and consult your physician before continuing.

WELCOME

Thank you for choosing Gymstick WalkingPad Pro, hereinafter referred to as a Treadmill. The exquisite, simple and innovative design enable you to enjoy your quality and enjoyable workout at home.

SPECIFICATION

Product and Accessories

Please check if the items inside the packaging box are complete and intact. In case of any missing or breakage, please contact the reseller.

Function Diagram

Walking Mode

Running Mode

Display Panel Function Introduction

Touch Key-press

Indicator Light

Remote Control

Initial Operating Guide

1. When pushing and pulling, please ensure that the handrail has shrunk to a minimum and fix the handrail locking and quick dismounting device. Put it on a flat floor, please don’t put it on too soft cushion or thick carpet.

2. Loose the handrail locking device, lift the handrail to a vertical angle, and tighten the handrail locking device.

3. Unfold the treadmill, adjust the walking belt to the center position, slowly unfold it and assist in pressing it down to make it completely flat, or rotate the bottom foot cushion for leveling.

4. Adjust the handrail quick mounting device to a suitable height, and then lock the device. Yellow marks on the handrail sides indicate the recommended maximum and minimum heights.

5. Install safety switch, connect power supply and tum on.

6. Download “KS Fit” APP from Apple Store or Google Play Store and complete installation.

7. Open APP, follow the prompts to add and bind the treadmill for use.

Learn to Use the Treadmill

Mode Description

• Standby Mode
  The standby mode indicator lights up, the motor and sensor stop responding.

• Manual Mode
  The manual mode indicator lights up, control the speed via remote control or APP.

• Automatic Mode
  The automatic mode indicator lights up, control the speed automatically via intelligent algorithm.

Standby Mode Control Description

• Under standby mode, users can press the mode button on the remote control briefly to wake up the treadmill and switch to the default manual mode state.

• Users can also touch the standby icon on the display panel to wake up the treadmill.

• When the treadmill is not running, press the mode button on the remote control or touch the standby icon on the display panel to switch to the standby mode.

• Short press: Mode switch

• Long press: Switch to standby mode (non-operational state )

Manual Mode Control Description(primary mode)

• In this mode, users can use the remote control to control the treadmill. Beginners are advised to use the manual mode first, and then use the automatic mode after being skilled in using it.

  *  **Short press:** Mode switch
  *  **Long press:** Switch to standby mode (non-operational state)

Automatic Control Mode Description(progressive mode)

• This mode is an progressive mode, which is difficult to control and can be used completely without the remote control. It is advised to use the mode after proficiency.
• Use the remote control to start and stop, and the mode switch button is effective under this mode.
  Note: The automatic control mode can only available under walking mode.

Remote Control Paring Instructions

• If the remote control does not respond or you have replaced the remote control, you need to re-pair.
• Pairing method: Restart the machine and press the mode button on the remote control for 5 seconds.

Connection Caution Light

• Not connected to APP: Flicker
• Connected to APP: Off

Fault Caution Light

• E01: Software overcurrent
• E02: Hardware overcurrent
• E03: 1PM Module Overheating
• E04: Low-voltage Protection
• E05: Overvoltage Protection
• E06: Motor phase loss protection
• E07: Motor block rotation protection
• E08: Sensor fault
• E09: Motor unable to start
• E12: Motor overcurrent protection
• E13: Overloading protection
• E14: Hall signal loss
• E15: Communication fault

Safety Instruction

1. The space distance behind the treadmill should be kept above 2000 mm. In case of emergency, you can hold the handrail tightly with both hands and support your body to jump off the treadmill.
2. The distance between the two sides of the treadmill should be kept above 500mm.
3. Do not wear loose or dangling clothing while using the treadmill, you should wear sports shoes and clothes. Please exercise according to your own situation. If you feel uncomfortable during the workout, please stop immediately and consult a doctor. Otherwise, you may be at risk of injury.

4. Read, understand, and test the emergency stop procedures before use. When using, please clamp the other end of the safe lock on clothes. If there is an unexpected situation, pull off the safety lock to stop the treadmill immediately.

5. Please unplug the power cord when not in use.

6. Do not step on the head of the treadmill.

7. Do not bring pets when using.

8. Do not operate electrically powered treadmills in damp or wet locations. Do not use it on an irregular ground.
9. Do not use the treadmill upside down or sideways.
10. Use with caution for the elderly, children and pregnant women

11. Watch your hands.
12. Take care of your belongings
13. Do not fold before power off

14. Keep treadmill upright and put it in the space with supporting points on both sides as far as possible, please stay away from children.
15. Do not get on and off the machine under running condition.

Start to use the treadmill

• The treadmill has an emergency stop mechanism for your safety. Before starting your Training, attach the safety key to your clothing. If the treadmill was switched off due to the safety key being pulled out, insert it again. The continuous belt does not start up again automatically.
• Uncontrolled use of the treadmill by a third party can be avoided by taking the safety key off and storing it in a secure place.
• In an emergency, hold the handrails tightly with both hands and step off of the belt onto the side surfaces of the side platforms. Activate the emergency stop mechanism (safety disconnect).

Maintenance

1. Clean the treadmill

   • Disconnect all power before servicing the treadmill.
   • Add a little mild detergent to the 100% cotton cloth. Do not spray the detergent directly on the walking belt or use acidic and corrosive detergent.
   • Do not wipe under the walking belt
   • After a period of exercise, dust and stains may appear on the rear floor. This is normal and just wipe.

2. Walking Belt Slipping and Correction

   • Start the treadmill and run at a speed of 3 km/h.
   • Walking belt to the left: Tum the left adjusting hole screw clockwise by 1/4 turn.
   • Walking belt to the right: Turn the right adjusting hole screw clockwise by 1/4 turn.
   • Walking belt slipping: Tum the left and right adjusting screws clockwise for 1/2 tum at the same time.
   • After each adjustment, it needs to run for a period of time (1-2 minutes) to observe the correction. Please adjust again if necessary.

3. Walking belt lubrication

   • Power off the treadmill and unplug the power cord
   • Lift the edge of the walking belt and smear the inner surface with silicone oil.
   • Start the treadmill to run at a speed of 3km/h for 10-20 seconds.
   • 5-10ml of silicone oil is required for one lubrication. Excessive application may cause slipping and affect normal use.
   • Lubricate your walking belt every three months

Implied Warranty

• The importer of this machine assures that this device is manufactured with high quality materials.
• The prerequisite for the implied warranty is the proper setup in accordance with the operating instructions. Improper use and /or incorrect transportation can void the warranty.
• The implied warranty is valid for 1 year, beginning from the date of purchase. For eventual defects please contact the dealer of this product within the guarantee period.
• The warranty applies to the following parts (as far as included in the scope of delivery): Frame, cable, electronic devices and wheels.
• The guarantee does not cover:
  • Damage effected by outer force
  • Intervention by unauthorized parties
  • Incorrect handling of the product
  • Non-compliance of the operating instructions
• Wear parts and expendable parts are also not covered.
• The device is only intended for home and office use. The warranty does not apply to commercial use of any kind.
• Manufactured for:
  • Gymstick International Oy
  • Ratavartijankatu 11
  • 15170 Lahti, FINLAND

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>