SENA RC4 Remote Control Instruction Manual
- June 3, 2024
- Sena
Table of Contents
SENA RC4 Remote Control
OVERVIEW
Getting Started
Remove the plastic tape from the battery slot to begin using the RC4.
INSTALLATION
Note:
If your handlebar requires better grip for holding the RC4 in place, apply the
rubber band around the handlebar.
Replacing the Battery
Button Operation
Power on /off
Battery Check
Bluetooth Pairing
Note:
- You can control the headset using the RC4 only after you pair them together.
- The RC4 supports Sena headsets with Bluetooth 4.1 or higher.
Factory Reset
Headset Control
To control your headset using the RC4, please refer to the Quick Reference Guide for button operations on functions such as phone, music, and intercom.
Note:
The Multifunction Button remotely controls special buttons such as the Ambient
Mode Button of the 20S and the Camera Button of the 10C. Please refer to the
Quick Reference Guide for more details.
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
RF Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specific operating
instructions for satisfying RF exposure compliance. The antenna used for this
transmitter must not transmit simultaneously with any other antenna or
transmitter, except in accordance with FCC multi-transmitter product
procedures.
When equipped, the distance between antenna and one’s lim is 0mm.
Sena Technologies, Inc.
www.sena.com
Customer Support: support.sena.com
References
- Sena FAQ, Downloads, Documents, Accessories & Videos | Sena
- SENA
- The Best Motorcycle & Action Sport Bluetooth Devices | Sena
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>