Baseus P2961 Bluetooth Headset User Manual
- June 12, 2024
- Baseus
Table of Contents
Baseus P2961 Bluetooth Headset
Product Information
Specifications
- Model: [Insert Model Number]
- Power: [Insert Power Rating]
- Dimensions: [Insert Dimensions]
- Weight: [Insert Weight]
- Colour: [Insert Color]
Product Usage Instructions
Setup
- Place the product on a flat and stable surface. Ensure proper ventilation around the product.
Power On
- Connect the power source to the product and switch it on using the power button.
Operating Modes
- Explore the different operating modes of the product by referring to the user manual for specific instructions.
Maintenance
- Regularly clean the product using a soft, damp cloth. Avoid using harsh chemicals that may damage the product.
Frequently Asked Questions
Q: Can the product be used outdoors?
A: Yes, the product can be used outdoors as long as it is not exposed to extreme weather conditions.
Q: How do I reset the product?
A: To reset the product, locate the reset button on the device and hold it down for 10 seconds.
Q: What should I do if the product malfunctions?
A: If the product malfunctions, refer to the troubleshooting section of the user manual or contact customer support for assistance.
Instructions for use
Operation method
- Power on/off
- Long press for 3 seconds, red and blue alternate flashing to enter Wireless mode
- Answer phone calls
- When calling (blue light flashing), click the power button once to answer
- End call
- During a call, click the power button 1 to end the call
- Play music
- Click the power button 1 in standby mode
- Pause music
- Click on the power button 1 during music playback to pause playback
- Music Size
- Long press+increase volume, long press – decrease volume
- Music Up and Down
- Press once+Previous track Press once – Next track
- Press the key
- Enter FM mode, TF card mode, Wireless mode
Product parameters
- Version: Wireless 5.1 + EDR
- Horn: 40mm
- Battery capacity: 200mAh
- Call time: 6-7 hours
- Signal-to-noise ratio: ≥ 85dB
- Frequency response range: 20Hz -20KHz
- transmission distance: ≥ 10M
- Impedance: 32 O
- Material: ABS
- Charging time: ≥ 2 hours
- Sensitivity: 113 + 3dB
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference
- this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, under Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used under the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>