SCHRADER ELECTRONICS MRXSCHBLE SCHBLE DTS TPMS Transceiver Instructions

June 12, 2024
Schrader Electronics

SCHRADER-ELECTRONICS-logo

SCHRADER ELECTRONICS MRXSCHBLE SCHBLE DTS TPMS Transceiver

SCHRADER-ELECTRONICS-MRXSCHBLE-SCHBLE-DTS-TPMS-Transceiver-
fig-1

Product Information

Specifications:

  • FCC ID: MRXSCHBLE
  • IC: 2546A-SCHBLE
  • Compliance: Part 15 of FCC Rules, Licence exempt RSS standards of Industry Canada
  • Operating Conditions: Must not cause harmful interference, must accept any received interference
  • Radio Frequency Exposure: Operate with a minimum separation distance of 20 cm (8 inches) from the body

Product Usage Instructions

Setup and Installation:
Before using the device, ensure that it is properly installed according to the manufacturer’s instructions.

Power On/Off:
To power on the device, press and hold the power button for a few seconds. To power off, repeat the same process.

Connectivity:
Enable Bluetooth on your device and search for available devices. Select the device from the list to establish a connection.

Operation:
Follow the specific instructions provided in the user manual for the functions and features of the device.

Maintenance:
Regularly clean the device using a soft, dry cloth. Avoid using harsh chemicals or solvents.

FAQ (Frequently Asked Questions)

  • Can I use the device while charging?
    Yes, you can use the device while it is charging. However, it is recommended to avoid prolonged use during charging for battery longevity.

  • How do I reset the device if it freezes?
    To reset the device, locate the reset button (usually a small hole) and gently press it using a paperclip or similar tool.

  • What should I do if the device encounters connectivity issues?
    Try turning off Bluetooth on both devices, then turn them back on and attempt to reconnect. If issues persist, consult the troubleshooting section of the user manual.

INTRODUCTION

The device under test is manufactured by the grantee (Schrader Electronics) and sold as an Aftermarket product. Per 47 CFR 2.909, 2.927, 2.931, 2.1033, 15.15(b) etc…, the grantee must ensure the end-user has all applicable / appropriate operating instructions. When end-user instructions are required, as in the case of this product, the grantee must notify the end-user.
Schrader Electronics will include the contents of this document in the end user’s manual for the commercial product.

FCC NOTE

This device complies with Part 15 of the FCC Rules and with Licence exempt RSS standards of Industry Canada.
Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. This device must accept any interference received, including interference that may cause undesired operation.

Exposure to radio frequency energy. The radiated output power of this device meets the limits of

FCC/ISED Canada radio frequency exposure limits
This device should be operated with a minimum separation distance of 20 cm (8 inches) between the equipment and a person’s body.
WARNING: Changes or modifications not expressively approved by the party responsible for compliance could void the user’s authority to operate the equipment. The term “IC:” before the radio certification number only signifies that Industry Canada technical specifications were met.

INFORMATION TO BE INCLUDED IN THE END USER’S MANUAL
The following information (in blue) must be included in the end product user’s manual to ensure continued FCC and Industry Canada regulatory compliance. The ID numbers must be included in the manual if the device label is not readily accessible to the end user. The compliance paragraphs below must be included in the user’s manual.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals