CC649005 Clutch Dormanter and Slave Cylinder Assembly Instruction Manual
- June 12, 2024
- DORMAN
Table of Contents
CC649005 Clutch Dormanter and Slave Cylinder Assembly
Product Information
Specifications
- Model: RWI120114-01
- Features: !, #, $, %, &, ‘, (, ), *, +, ,, -, ., /, 0, 1
Product Usage Instructions
To power on the device, press the! button. To power off the device, press the
button and hold for 3 seconds.
For initial setup, follow these steps:
- Press the $ button to enter setup mode.
- Use the % and & buttons to navigate through the setup options.
- Adjust settings using the ‘ and ( buttons.
- Confirm settings by pressing the ) button.
Functionality
- Use the * button to activate different functions.
- Press the + button to increase values and the button to decrease values.
- The – button can be used to cancel or go back to the previous menu.
Troubleshooting
- If you encounter any issues with the product, refer to the user manual for specific troubleshooting steps.
- If problems persist, contact customer support.
FAQ
- Q: What should I do if the device does not power on?
- A: Check the battery level and ensure it is charged. If the issue persists, contact customer support for further assistance.
- Q: How do I reset the device to factory settings?
- A: Press and hold the ! and * buttons simultaneously for 10 seconds to reset the device to factory settings.
REMOVAL & REPLACEMENT OF EXISTING CLUTCH INTERLOCK SWITCH POSITION & RETENTION CLIP
Warning: The Clutch Interlock Switch Position & Retention Clip must be installed for the proper function of the clutch actuation system.
Installation And Using Instructions
- You will need to remove the interlock switch from the master cylinder pushrod. Slide a flat-blade screwdriver under the white cover of the switch assembly and apply pressure to lift over the retention tab.
- Lift the switch cover and remove it from the switch.
- To remove the switch, push down on the switch un-clipping it from the pushrod. Continue pulling down on the switch to remove the location tab from the retention clip.
- Take note of how clip ends are locked in behind the position tabs on the master cylinder housing. Will need to make sure that the clip ends are in the same position when the clip is assembled to the new master cylinder housing.
- Lift slightly on the ends of the clip until the clip can slide up onto the bore opening of the master cylinder.
- Slide clip off the end of the old master cylinder.
- Spread the ends of the clip apart and slide over the bore end of the new master cylinder.
- Slide the clip down into the groove of the new master cylinder making sure that the clip ends lock in behind the location tabs as shown in step 1.
- Reinstall the switch and cover.
Note: Installation orientation of clip/switch is critical!
CONTACT
Technical Support
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>