MASATA MST7002 Series BMW F40 M135iX Tuning Box Installation Guide

MASATA MST7002 Series BMW F40 M135iX Tuning Box Installation Guide

Before Installation

1. 1. Open the vehicle’s bonnet
2. Remove the ignition key
3. Close and lock the doors
4. Wait 5 minutes before
   removing any electrical plugs

Installation Location
The module should be installed between the vehicle’s Rail and Boost Pressure sensors as shown in the diagram.

Locating the Unit
The unit itself should be mounted away from

Sources of Extreme Heat
Sources of Vibration
Sources of Spray Water
Do not open the vehicle doors or unlock the vehicle while installation is in progress

INTRODUCTION

• You do not need to remove the plastic engine cover to install the unit to this engine.
• Familiarize yourself with the locations of the connectors highlighted.
• Make sure that you have a good grasp of the operation of the connector clips and or locking tabs. – If the connectors you are trying to access are in an awkward place, it may be useful to try unplugging (and then re-inserting) a connector on the vehicle which is more easily accessible. Alternatively try plugging together the connectors on the Tuning Module itself.

STEP 1

• Unplug the MAP Sensor connector (3 pin) by pressing down the releasing clip and pulling back on the connector.
• Insert the connector from the Tuning Module’s wiring loom into the MAP Sensor.
• Insert the Vehicle’s MAP Sensor connector into the corresponding connector on the Tuning Module’s wiring loom.
• Secure the MAP wiring loom.

STEP 2a

• Remove the two bolts holding in the intake duct in order to gain access to the boost sensor (highlighted in red)

STEP 2b

• Unplug the boost sensor connector (4 pin) by pressing down the releasing clip and pulling back on the connector.
• Insert the connector from the Tuning Module’s wiring loom into the boost sensor.
• Insert the Vehicle’s boost sensor connector into the corresponding connector on the Tuning Module’s wiring loom.
• Secure the boost wiring loom.

STEP 3
   

• To access your CAM sensor, you will need to remove your engine cover, do this by giving it a gentle tug.
• Unplug the Cam Sensor connector (3 pin) by pressing down the releasing clip and pulling back on the connector.
• Insert the connector from the Tuning Module’s wiring loom into the Cam Sensor.
• Insert the Vehicle’s Cam Sensor connector into the corresponding connector on the Tuning Module’s wiring loom.
• Secure the Cam wiring loom in place.

BMW/Mini B38/48 3 Channel unit

•  Carefully re-install all engine covers that have been removed during the installation process.
•  With the unit successfully installed please secure the unit and wiring loom within the engine bay, paying attention to the guidelines highlighted on Page 1.

Route the tuning box wiring harness away from sources of heat (exhaust manifolds, EGR pipes, most stainless steel pipes) and also away from any rotating parts such as belts.

• Double check all connections are correct and firmly connected. If this is the case, start the vehicle and ensure there are no engine warning lights or error messages displayed.

If everything is as it should be, please feel free to take the vehicle out for a test drive and
enjoy the added responsiveness and power added to your vehicle by the Tuning Module.

HЗа-H4-H3a-E-796

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>