JOYROOM JR-ZS408 Magnetic Wireless Car Charger Holder User Manual
- June 12, 2024
- Joyroom
Table of Contents
JR-ZS408 Magnetic Wireless Car Charger Holder
Model: JR-ZS408
Magnetic Wireless Car Charger Holder
User Manual
Parameters
Model: JR-ZS408
Name: Magnetic Wireless Car Charger Holder
Material: zinc alloy
Input: 5V 2A 9V 2A 12V 2A
Output: 5W/7.5W/10W/15W (MAX)
Input port: Type-C
Size: ≈706025mm
Net weight: ≈158g
Applicable phone size: 4.7-7.0”
Product diagram
Accessory kit
Metal ring x1, Separation film x1,
Cleaning kit x1, Alignment card x1
Installation steps
-
Clean the dashboard where you need to install the car holder with a wet cloth, and wait for it to dry.
-
Tear off the bottom sticker (DO NOT touch the adhesive with your fingers).
-
Install the car holder onto the desired place, press and hold for 30s, wait for 12h before use for the best performance.
-
Use the Type-C charging cable in the package to connect the holder and the car charger.）
It is recommended to use a car charger of 18W or above
-
Place your phone. It will be securely attached to the charger holder with its auto alignment function.
Reminder: The product can be used directly with iP mag-safe phones with/without a magnetic case. For other phones and cases, a metal ring is required.
Operation steps (metal ring)
-
Open the cleaning kit, wipe clean the back surface of your phone.
-
Paste the transparent separation film onto the center of the phone back.
-
Adhere the metal ring onto the center of the phone back by use of the alignment card.
Note: Just make sure the upper and lower scales as well as the left and right scales of the alignment card are equal, the metal ring will be adhered to the center.
FCC Requirement
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. This
device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy, and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
© 2024 Shenzhen Nito Power Source Technology Co., Ltd.
All Rights Reserved / Designed by JOYROOM /
www.joyroom.com / Made in China
3.1101.621709.0000000
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>