iRIS Remote Controller System Installation Guide
- June 8, 2024
- IRIS
Table of Contents
iRIS Remote Controller System
BEFORE YOU START
The iRIS lighting system is designed to be used with the Spa Electrics MULTI PLUS model lights. (Please check product labeling to ensure it is suitable) For Retro-fit installations, where existing transformers have been hardwired; a suitably qualified electrician must disconnect the transformers and terminate with a plug top connection. OR the transformers are to be replaced with the Spa Electrics LV25-12 or LV50-12 models.
INSTALLATION
- Mount receiver in a suitable location, adjacent to the pool lighting transformers. (Minimum elevation above ground is 500mm)
- Plug receiver into the mains supply
- Plug pool light transformer into outlet marked ‘POOL’
- Plug spa light transformer into outlet marked ‘SPA’
Note: For systems with 2 or more pool lights, use the LV50-12 transformer andutilise the piggyback feature on the LV50-12 to ensure all transformers are switched together.
MULTI PLUS QUICK SETUP
- STEP 1 Ensure the lights have been OFF for a minimum of 30 seconds, then turn the system ON using the iRIS handset.
- STEP 2 Press the following static colours in order with a 1 second pause between each press.
- WHITE
- RED
- GREEN
HANDSET OPERATION
HANDSET PAIRING
Your Remote handset should come pre-assigned to your receiver. However if it is not paired or you would like to program a second handset, please follow the below instructions:
STEP 1 Press the ‘LEARN’ button on the base of the receiver. The receiver will now switch to learning mode, indicated by the red LED located next to the ‘LEARN’ button.
STEP 2 Within 7 seconds press any of the buttons on the Remote Handset. The remote handset is now assigned to the receiver.
MEMORY RESET
To reset the receiver memory, press and hold the ‘LEARN’ button continuously;
The LED indicator will flash fast initially then flash slow indicating the
memory has been erased. Once erased, release the ‘LEARN’ Button and complete
steps 1 & 2 to program the handsets.
TECHNICAL SPECIFICATION
RECEIVER RATING
- Input: 230-240VAC ~ 50Hz
- Output: 2 X 240VAC ~ 50Hz switched
- Max. Load: 2400W MAX. TOTAL
REMOTE
- Battery: 2 x ‘AAA’
- Range: Up to 50m – line of sight
- Freq: 800MHz
TROUBLESHOOTING
FOR ASSISTANCE PLEASE CONTACT SPA ELECTRICS
- ph: +61 3 9793 2299
- info@spaelectrics.com.au
- www.spaelectrics.com.au
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>