D-Link DES-1009MP 9-port 10/100 PoE Switch Installation Guide
- June 6, 2024
- D-Link
Table of Contents
Quick Installation Guide
DES-1009MP
Before You Begin
This Quick Installation Guide gives you step-by-step instructions for setting up your DES-1009MP 9-port 10/100 PoE Switch. The model you have purchased may appear slightly different from the one shown in the illustrations.
Package Contents
This DES-1009MP package should include the following items:
- 1 x DES-1009MP
- 1 x Power adaptor
- 1 x Quick Installation Guide
If any of the above items are damaged or missing, please contact your local D-Link reseller.
Hardware Overview
LED Indicators
| LED| Status| Description
---|---|---|---
1| Power| Solid green| The switch is powered on.
Off| The switch is turned off.
2| Link/AmSpeed(LeftLed)| Solid green| There is an active link
negotiated on this port.
Blinking green| There is traffic at the port.
Off| There is no active link on this port.
3| PoE(RightLed)| Solid green| The port is providing power to the
connected PoE-powered device.
Blinking green| This indicates a PoE-powered device is connected to this PoE
port, but the switch has insufficient remaining power budget to power the
device.
Off| There is no PoE-powered device connected to this port.
Table 1: LED overview
Front Panel Connectors
| # | Interface | Description |
|---|---|---|
| 1 | Ports 1 -8 | 10/100 Mbps PoE-capable ports, used for connecting Ethernet |
devices and PoE-powered devices.
2| Ports 9| 10/100/1000 Mbps Ethernet port for uplink connections to NVR,
storage, or core switch.
Table 2: Front connector description
Rear Panel Connectors
| # | Connector | Description |
|---|---|---|
| I | DC Power Input | Input jack for the power adapter. |
| 2 | SWITCH GND | The screw is used to secure a grounding wire to connect the |
switch to the ground.
Table 3: Rear connector description
Hardware Installation
Installation Precautions
For safe switch installation and operation, it is recommended to:
- Visually inspect the DC power jack and make sure that it is fully secured to the power adapter.
- Make sure that there is proper heat dissipation and adequate ventilation around the switch.
- Install the switch in a site free from strong electromagnetic sources, vibration, dust, and direct sunlight.
- Not place heavy objects on the switch.
Grounding the Switch
The following steps explain the procedure for connecting the switch to a protective ground:
- Verify that the system is powered off.
- Remove the ground screw and place the #8 terminal lug ring at one end of the ground cable on top of the ground screw opening.
- Insert the ground screw back into the ground screw opening.
- Using a screwdriver, tighten the ground screw to secure the ground cable to the switch.
- Attach the terminal lug ring at the other end of the grounding cable to an appropriate grounding source.
- Verify that the connections from the ground connector on the switch to the grounding source are securely attached.
Powering On the Switch
After connecting the switch to the network using a compatible category 5/6/7 UTP network cable, simply connect the switch to a power outlet to power the device.
TECHNICAL SUPPORT dlink.com/support
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>