Shark NV700 Series DuoClean with Zero-M Lift-Away User Manual
- June 9, 2024
- Shark
Table of Contents
Shark NV700 Series DuoClean with Zero-M Lift-Away User Manual
NV700 Series
QUICK START GUIDE
[ Please be sure to read the enclosed Shark® Owner’s Guide prior to using your unit. ]
This article contains the Quick Start Guide for the NV700 / UV700 Series Shark® DuoClean® with Zero-M® Lift-Away®. This supports the following product SKUs UV700 and NV700.
Use this Quick Start Guide to learn about your new vacuum’s great features.
WHAT’S INSIDE:
A. Vacuum Pod
B. Motorized Floor Nozzle
C. Handle & Hose
D. Wand
E. Pet Multi-Tool
F. Duster Crevice Tool
Attach onboard accessories
ASSEMBLY
1. Attach vacuum pod to floor nozzle.
2. Insert wand into pod.
3. Insert handle and hose into wand.
4. Press hose into back of pod.
For complete maintenance instructions, see the enclosed Owner’s Guide.
For additional parts and accessories, visit sharkaccessories.com
2 WAYS TO CLEAN:
1. UPRIGHT
Power
Press the Power/Surface
Selector button to turn the vacuum on or off.
Floor Setting
Slide the Power/Surface
Selector button up or down to choose floor type.
2. LIFT-AWAY
MAINTENANCE
Zero-M™ Technology
Zero-M Technology™ actively removes hair wrap from your brushroll while you vacuum. If you run over a hard or sharp object or notice a noise change while vacuuming, check for blockages or objects caught in the brushroll.
CLEANING THE BRUSHROLL
To open the brushroll garage, slide both release buttons on the floor nozzle
away from you, towards the back of the nozzle, then lift off the lid. Clear
away any objects or debris.
To close the brushroll garage, insert the 3 tabs on top of lid into the 3
slots in the nozzle, then push down on both sides of lid until it clicks
securely into place.
NOTE : If any hair is wrapped around the brushroll, extending cleaning time will allow Zero-M™ technology to remove it for you. If some fibers remain wrapped around brushroll after continued use, carefully cut debris with scissors and remove from brushroll.
CLEANING THE SOFT ROLLER
To remove the Soft Roller from the nozzle, lift it out by the pull tab. Tap loose debris off the Soft Roller. Use a dry towel to wipe the Soft Roller clean, or to remove any debris caught in the teeth behind the Soft Roller.
Hand wash the Soft Roller as needed. Use only water, and let air-dry completely for at least 24 hours. Reinsert the Soft Roller under the rubber bumper in the front of the nozzle until it clicks into place.
To register your product, or for answers to frequently asked questions, visit registeryourshark.com.
©2018 SharkNinja Operating LLC. SHARK is a registered trademark of SharkNinja Operating LLC.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>