blumfeldt Bonaparte Fire-Blanc Gas Heater User Manual

User Manual

blumfeldt Bonaparte Fire-Blanc Gas Heater

Dear Customer,
Congratulations on purchasing this device. Please read the following instructions carefully and follow them to prevent possible damages. We assume no liability for damage caused by disregard of the instructions and improper use. Scan the QR code to get access to the latest user manual and more product information.

DECLARATION OF CONFORMITY

Producer:
Chal-Tec GmbH, Wallstraße 16, 10179 Berlin, Germany.
The complete declaration of conformity of the manufacturer can be found at the following link: https://use.berlin/10032817

SAFETY INSTRUCTIONS

• Read the instructions for use before using this device.
• This equipment must be installed by a qualified person.
• This appliance requires a hose and regulator, consult your gas dealer.
• Use the appliance only in a well-ventilated area.
• Do not use the appliance in recreational vehicles such as caravans and motor homes.
• Please follow the instructions for use when replacing gas cylinders.
• In the event of a gas leak, the gas supply to the appliance must be cut off at the gas cylinder valve.
• The heater must not be near other heat sources (at least 1 meter distance) or flammable/explosive materials and must not come into contact with objects that can be damaged or burned (for example curtains, armchairs or furniture).
• Position the heater so that the heat radiates towards the center of the room. The front, radiating part of the heater must be at least 2 meters away from curtains, sofas, furniture or other objects.

PRODUCT OVERVIEW

ASSEMBLY

Hints for assembly

• Please note that the packaging and transport locks must be removed before assembly.
• After unpacking, check for possible damage. If you are not sure, contact qualified specialists. Keep the packaging material out of the reach of children, as it may present a danger. Dispose of the packaging material according to the legal regulations.

Installation steps

• Guide the rear base (15) in the direction of the arrow into the guide of the front base. Push the rear base forward. Fasten the rear base to the front base with 2 M8 screws and washers.
• Insert the door of the gas cylinder container (4) into the guides on the side of the housing.

Replacing the battery

• Remove the cover of the ignition (7) by turning it counterclockwise. Insert a battery of type LR03
• Insert the negative pole of the battery first, then put the cover (14) back up and tighten it clockwise.

GAS CYLINDER CONNECTION AND LEAK DETECTION

• There may be slight deviations. This is not due to the quality, but is subject to product improvements.
• The device may only be operated with a liquid gas container of less than 15 kg.
• The pressure regulator must comply with the EN12864 standard. The hose must comply with the EN1763-1 standard and be no longer than 50 cm.
• Connect one end of the hose to the pressure regulator and the other end to the tap. Ensure that the connections are tight and that the components and fittings are not damaged.
• The gas tap must be closed before connecting to the gas cylinder and there must be no open flames in the vicinity (burning oven, etc.). The seal must be in good condition. Then screw the pressure regulator to the gas cylinder.
• Place the pressure regulator on the gas tap. Tighten the nut counterclockwise.
• Check carefully that no gas comes out of the supply line. Use soapy water (1 part detergent, 2 parts water). If there is a leak, bubbles will rise. Tighten the connection more tightly or consult a specialist.
• Place the gas bottle in the container. Make sure that the hose is not kinked or choked and does not touch any hot parts.
• Hang the door for the gas cylinder chamber (see installation).
• When replacing the gas cylinder, make sure that the gas tap is closed and that there are no open flames (burning ovens, etc.) or heat sources in the working area nearby.
• The hose must be replaced every 2 years.
• Check the gas hose once a month and every time the gas cylinder is changed. If there are signs of cracking, splintering or other damage, the hose must be replaced.
• Do not tamper with the connections and other components incorrectly.
• Do not turn the gas cylinder upside down to use up the rest of its contents completely. This will result in the leakage of fluid residues that will irreparably damage the gas heater.

OPERATION

Note: Always access the controls and gas valve from the side of the gas heater. Do not attempt to reignite the gas heater until 5 minutes have passed.

Lighting the Gas Heater

• Open the gas valve of the gas cylinder.
• The rotary knob must be in the position . Push it down completely. This will allow the gas to flow into the igniter and the burner. While still holding the knob down, press the ignition button to start the ambient air sensor (ODS).
• If the pilot flame is not lit, release the knob and wait 30 seconds to repeat the process.
• If the pilot light is lit, hold the knob for another 20 seconds (without pressing it) until the ODS remains lit.
• Release the head and turn it to the desired heating level.

Switching off the gas heater

• Turn the knob to the position .
• To switch off the appliance, close the gas valve on the gas cylinder.
• Do not move the gas heater during operation.

REPAIR AND MAINTENANCE

Maintenance
To ensure that you can enjoy the heater for a long time, carry out the following maintenance work regularly.

• Repairs may only be carried out by qualified specialists.
• Keep the surfaces clean on the outside.
• Clean the outside of the gas heater with a damp soft sponge and a liquid cleaner. Do not use scouring sponges or abrasive cleaners.
• Do not use water, flammable cleaners or scouring agents directly on the appliance.
• Check the ambient air sensor and the ventilation openings. If there is dust or lint, remove it without damaging the burner or wiring.
• Be careful not to damage the surface of the burner, the connections and gas hoses.
• An annual inspection of the appliance by specialists is recommended.

Storage and disposal
If you do not use the gas burner for a long time, follow the steps below:

• Close the gas tap and disconnect the pressure regulator from the gas cylinder.
• Store the gas cylinder in a well ventilated place, far away from flammable or explosive materials, preferably outside the house. Never store the gas cylinder in the cellar or attic.
• The gas heater must be stored in a dry place and protected from dust, preferably in its original packaging.
• If you decide to stop using the appliance, we recommend that you disconnect the gas bottle after following the steps above. Disable the device by cutting the hose. If there is a danger of children playing with it, make the dangerous parts harmless.

PRODUCT DATA SHEET

Warning notes:

• Read the instructions for use before using this device.
• This device must be installed by a qualifi ed person.
• A hose and regulator are required for this appliance, consult your gas dealer.
• Use the appliance only in a well ventilated area.
• Do not use the appliance in recreational vehicles such as caravans and motor homes.
• The room in which the appliance is installed must have an air supply over an area of at least
  105 m2 , evenly distributed above and below.

Chal-Tec GmbH, Wallstr. 16, 10179 Berlin, Germany
www.elektronik-star.com

Read More About This Manual & Download PDF:

blumfeldt Bonaparte Fire-Blanc Gas Heater User Manual – Download [optimized]
blumfeldt Bonaparte Fire-Blanc Gas Heater User Manual – Download

Questions about your Manual? Post in the comments!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>