Amazon Basics B001FHPVEU Mid Back Office Chair Instruction Manual

Mid Back Office Chair

Contents

Make sure that the package contains the following parts:

Assembly Instructions

Step 1: Turn the star base upside down, then press the casters into the holes at the end of each base leg.

Step 2:  Turn the star base upright and insert the lift into the center hole of the star base. The lift cover should be placed over the lift.

Step 3: Align the seat plate over the pre-drilled holes underneath the seat cushion. Make sure that the front of the seat plate is facing the front of the seat cushion. Attach the seat plate to the seat cushion using four 7/8” (A) bolts. Tighten all the bolts with the wrench, being careful not to miss- thread the bolts or damage the seat.

Step 4 : Turn the seat cushion upright and align the center hole of the seat plate over the lift, then push the seat cushion down onto the lift firmly until the connection is secure.

Step 5:  Attach the arms to the seat cushion with four 3/4” (B) bolts, using the wrench.

Note : Arm rests are labeled with an “L” (left) or “R” (right) to show which sides they should be placed on.

Step 6: Lay the back cushion on the seat of the chair with the top of the cushion toward the front.

Attach the back cushion to the arms by inserting two 3/4” (B) bolts in the lower holes with the wrench. Do not tighten the bolts fully.

Step 7:  Rotate the back of the chair up, then secure it with the top two 3/4” (B) bolts. Fully tighten all the bolts.

Step 8: Press the plastic caps into the arm holes to cover the bolts.

Caution:

For your safety, before using your chair, make sure that all of the bolts are fully tightened. Keep the enclosed wrench and check the bolts periodically to make sure they remain securely tightened.

Adjustments

Adjusting the seat height

To raise your seat, lean forward to lift your body weight from the seat, then pull up the control handle. To lower the seat, pull up the control handle while you’re seated.

Adjusting the tilt tension

Turn the tilt knob clockwise to make it easier to rock your chair backwards. Turn the tilt knob counter-clockwise to make it harder to rock your chair backwards.

Note: If your chair won’t tilt back, pull out the control handle.

Operating the tilt lockout

To let your chair tilt back, pull the control handle out.
To stop your chair from tilting, sit forward, then push the control handle in.

Safety and Compliance

• Use care when handling.
• Please read the instructions completely before assembly.
• Remove all parts from the carton and ensure all parts are included prior to assembly.
• Assemble the chair on the carton or carpet to prevent scratching the chair.
• Be careful not to cross-thread bolts.
• Do not use power tools.

Specifications

Dimensions (H x W x D)

|

34.84-38.58 x 24,02 x 24.02 inches

(88.5 – 98 x 61 x 61 cm)

---|---

Maximum load weight

|

225 lbs. (102.1 kg)

ATTENTION: ALL REPAIR WORK OR EXCHANGE FOR THE HEIGHT ADJUSTABLE GAS LIFT MUST BE DONE BY SPECIALISTS.

Amazon Basics B001FHPVEU Mid Back Office Chair Instruction Manual – Download [optimized]
Amazon Basics B001FHPVEU Mid Back Office Chair Instruction Manual – Download

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>