ELECOM MSC-TB-APSG-W Glass Screen Protector With Guiding Frame User Manual

ELECOM MSC-TB-APSG-W Glass Screen Protector With Guiding Frame

Before attaching

• Place the screen protector on the LCD screen and make sure that it is aligned.

Precautions

• If dirt and oil remain on your LCD screen, you may not be able to successfully put on the film.
• If dust remains on the LCD screen, it will cause the LCD screen to be scratched.
• When putting on the film, ensure that you do not touch the side of the screen protector that will be attached to your screen, and avoid leaving fingerprints and dust.
• Do not press the LCD screen strongly to remove air bubbles. This may damage or cause your device to fail. T
• The images are for illustration purposes only.

1. Turn off your device and wipe off the dirt on the screen with the included cleaning cloth.

2. Please remove the dust on the screen cleanly using the attached dust remover sticker.
   

3. Attach the guide frame to the device body according to the orientation of the words on the guide frame.

4. Remove the protective sheet on the screen protector and attached it to the screen. This side will be attached to the screen after the protective sheet is removed.
   

5. Check the position of the camera on the device and apply the film in alignment with the guide frame.

6. Affix the center as shown in the figure and put on the film in such a way that the bubbles are forced out from the center to the edge. Remove the guide frame after applying the film and before use.

How to remove air bubbles

If air bubbles remain after attaching the screen protector, use the spatula or your finger to lightly press the bubbles to the edge of the protector to remove it. Small air bubbles will become smaller and less noticeable over time.

• Do not use your fingernails to remove the air bubbles. Doing so may scratch the film. Applying excessive pressure may cause damage to the screen. Depending on the size of the air bubbles, some may not disappear.

To remove the affixed screen protector
To remove the screen protector, slide the protection sheet between the screen protector and the device. Slowly lift the screen protector off so that does not bend too much.

• Bending the screen protector too much when removing it may lead to breakage. * The screen protector may break if forcibly removed with your finger. Please use the protective sheet to remove it.

Precautions on use

• This product is made of glass. If it breaks, please discontinue use and remove the screen protector with care.
• This product is a screen protector for protecting the LCD screen of your device. Do not use it in any other way.
• This product does not completely prevent scratches and dirt on the LCD screen.
• Be sure to observe the following when using it.
• Do not use it other than with compatible devices.
• Please be aware that we accept no responsibility for any damage, breakdown, or data loss for your device.
• Stop using the product immediately if you notice damage such as cracks, deformation, or deterioration on the product.
• Do not allow alcohol and other chemicals such as medicines and detergents to touch this product.
• Do not use rough cloths to clean this product.
• Keep out of reach of children.
• Due to the nature of the material, this product may discolor over time.
• Please note that we accept no responsibility for any damage or fault caused to the screen during application or removal of the screen protector.
• Due to the nature of this product, the screen protector may get stuck and be removed when putting in or taking out your device from bags.

Compliance status: https://www.elecom.co.jp/global/certification/

ELECOM CO., LTD.
MSC-TB-APSG-W_en_ver.1

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>