MYKRONOZ Wireless ZeBuds User Guide

User Guide

MYKRONOZ Wireless ZeBuds

OVERVIEW

CHARGING

Before the first time use, make sure to fully charge ZeBuds inside their charging box with the USB-C cable for about 2 hours.

ZeBuds and its charging case will reach maximum battery capacity in order to provide you with up to 12 hours playtime.

ZeBuds can deliver about 3 hours of battery life. When reaching low battery level, you will hear an audio indication in your earbuds inviting you to put them back in the charging case to recharge them.

It will take about 90 minutes to fully charge your earbuds in the charging case. Once the charging case is fully charged, you can recharge your earbuds up to 3 times until it reaches low battery.

LED INFORMATION

There are 3 LED indicators in the charging case to indicate its built-in battery level.

• 3 LEDs ON = between 75% and 100%
• 2 LEDs ON = between 25% and 75%
• 1 LED ON = below 25% and requires your attention
• LED OFF = 0% battery

PAIRING

In order to pair your ZeBuds with your smartphone, please follow the below instructions:

• Open the charging case and take out both earbuds. The white LED on either earbud will start flashing slowly to indicate it is in pairing mode
• Go to the Bluetooth® settings of your smartphone and search “ZeBuds”
• Select “ZeBuds” in the list to initiate pairing
• Once pairing is confirmed, white LED on either earbud will stay solid state for one second then turn off
• Your left and right earbuds will connect to each other automatically thanks to the TWS technology in order to provide you with Wireless Stereo audio signal
• You’re now ready to enjoy your new ZeBuds

Note: You can independently use your left or right earbud by storing the one you don’t want to use back in the charging case. The Bluetooth® pairing mode will automatically stop after 5 minutes of searching for device. To resume the pairing mode, please put both earbuds back in the charging case for a few seconds then take them out again.

HOW TO PAIR WITH ANOTHER SMARTPHONE

To pair your ZeBuds with another phone, please first forget ZeBuds from your smartphone’s Bluetooth® list, then perform a new pairing procedure with another smartphone.

OPERATIONS

*use either earbud to conduct these operations

TROUBLESHOOTING

Pairing failed

1. Put the earbuds back to the charging case.
2. Wait 15 seconds. Then take the earbuds out of the case.
3. Wait until the LEDs on both earbuds flash slowly and enter the pairing mode.
4. Select “ZeBuds” from the list of detected Bluetooth devices.

If the pairing still fails, please check the following points:

• Make sure the earbuds and your Bluetooth® device are near each other.
• Try to reboot your Bluetooth® device.

Connection is not stable

• Make sure the earbuds and your Bluetooth® device are inside their Bluetooth® range.
• Ensure that the earbuds have enough battery power.
• Put the earbuds back to the charging case. Wait 15 seconds. Then take the earbuds out of the case.
• Try to reboot your Bluetooth® device.

TECH SPECS

EARBUDS:

• Bluetooth® 5.0
• Dimensions: 17.84319 mm
• Weight: 5 g each
• Battery type: 40 mAh
• Battery life: up to 3h of playtime
• Charging time: 20 min for 1h listening / 1h30 full charge Dual microphone
• Speaker impedance: 32Ω
• Frequency: 20Hz/20KHz
• IPX4 water resistant
• Operating temperature: -10°C to +60°C

CHARGING CASE:

• Dimensions: 46.55822.3 mm
• Weight: 48 g
• Battery type: 400 mAh
• Battery life: 9h of extra playtime
• Charging time: 1h30 for full charge
• USB-C charging port

Compatible with iOS and Android devices.
1 year international warranty.

WHAT’S IN THE BOX

• ZeBuds with charging case
• 1x USB-C charging cable
• 1x Quick start guide

SAFETY INSTRUCTIONS

• To prevent possible hearing damage, do not listen at high volume levels for long periods
  of time.

• Use of earbuds will prevent your ability to hear other sounds.

• Use your earbuds with caution when engaging in any activity that requires your full attention.

• This package contains small parts that may be hazardous to children and should be kept out of reach from children. This product is not a toy never allow children to play with this product.

• Never try to dismantle the product yourself, or push objects of any kind into the products, as this may cause short circuits, which could result in a fire or electric shock.

• None of the components can be replaced or repaired by users. Please contact customer service for any assistance.

• Avoid exposing your product to rain, moisture or other liquids to protect against damage to the product or injury to you.

• Do NOT submerge the earbuds in water.

• Do NOT expose the earbuds to moving water (e.g., from a faucet, etc.).

• Do NOT wear the earbuds while showering or bathing, or when participating in water sports, e.g., swimming, waterskiing, surfing, etc.

• Leaving the product in hot or cold places, such as in a closed car in the summer and winter conditions, will reduce the capacity and lifetime of the earbuds.

• Read all the instructions before using the charging case.

• Do not expose charging case to water, rain, liquids or snow.

• Use of a power supply or charger that is not recommended may result in a risk of fire or injury.

• Do not use the charging case in excess of its output range.

REGULATORY NOTICES

USA FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

CAUTIONS
Any changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.

FCC NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.

FCC ID: 2AA7D-ZEBDS

RF EXPOSURE STATEMENTS
This equipment complies with FCC radiation exposure requirement set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance.

CANADA ISED STATEMENT
This device complies with Industry Canada license-exempt RSSs. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. This Class B digital apparatus complies with Canadian ICES-0003.

RF EXPOSURE STATEMENTS
This device complies with the ISED RSS-102 RF exposure requirement set forth for an uncontrolled environment and are safe for intended operation as described in this manual.

CE DIRECTIVE

KRONOZ LLC hereby declares that the device is in compliance with the essential requirements and other relevant provisions of directives 2014/53/EU and 2012/19/EU. The original EU declaration of conformity may be found at SZ19-0147ZeBuds [PDF]

   DISPOSAL AND RECYCLING INFORMATION
After the implementation of the European Directive 2012/19/EU in the national legal system, the following applies: electrical and electronic devices may not be disposed of with domestic waste. Consumers are obliged by law to return electrical and electronic device at the end of their service lives to the public collecting points set up for this purpose or point of sale. Details to this are defined by the national law of the respective country. This symbol on the product, the instruction manual or the package indicates that a product is subject to these regulations. By recycling, reusing the materials or other forms of utilizing old devices, you are making an important contribution to protecting our environment.

©2019 Kronoz LLC, all rights reserved. Kronoz LLC, Avenue Louis-Casaï 18, 1209 Geneva, Switzerland All brands or product names are or may be trademarks of their respective owners. Pictures and specifications are not contractual.
Designed in Switzerland – Assembled in China

References

• MyKronoz Official Store - Buy Smartwatches and Activity trackers designed in Switzerland – MyKronoz
• MyKronoz Official Store - Buy Smartwatches and Activity trackers designed in Switzerland – MyKronoz

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>