HAGOR 8703 HA Gasliftarm Dual Installation Guide
- June 13, 2024
- HAGOR
Table of Contents
HAGOR 8703 HA Gasliftarm Dual Installation Guide
Caution!
Technical devices are of considerable value. You should therefore handle the components carefully during installation and protect them if necessary.
If necessary, the installation area should also be secured. Falling parts can cause injuries and material damage.
The materials included in the scope of delivery may not be suitable for the special conditions at the installation site. Please check this in advance and replace it with suitable materials if necessary.
If you are unsure about the installation of the product or have any questions, please contact us or other trained specialists.
Scope of delivery
-
A (x1)
-
B (x1)
-
I (x1)
-
J (x1n)
-
C (x1)
-
D (x1)
-
E (x1)
-
F (x1)
-
G (x1)
-
H (x2)
-
K (x2)
-
L (x2)
-
M (x2)
-
N (x2)
-
O (x2)
-
P (x4)
-
Q (x2)
-
R (x4)
-
S (x1)
-
T (x1) 4mm
-
U (x1) 6mm
-
M-A (x4) M4x12
-
M-B (x4) M5x12
-
M-C (x4) D5
Clamp mounting
Grommet mounting
Adjustment
To properly balance the gasliftarm with monitors mounted, adjust the spring tension by using the supply of an Allen Key as follows:
First, position and firmly hold the arm horizontally as shown. Ask for assistance if you require it.
To avoid damage to monitors or mount, always keep the arm in a horizontal position while making adjustments. Again, ask for assistance if required.
If the arm drops, turn the adjustment screw counter-clockwise until it stays
in a horizontal position (Picture 2).
If the arm rises, turn the adjustment screw clockwise until it stays in a
horizontal position (Picture 2).
DO NOT over tighten the screws.
If the display does not stop in the desired position tighten the screws as
shown.
Dimensions
HAGOR Products GmbH | Oberbecksener Straße 97 | D-32547 Bad Oeynhausen | Telefon: +49(0)57 31-7 55 07- Mail: hagor@hagor.de
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>