Johan Lewis Fin Gray Aluminum Metal Pendant light User Manual

: June 7, 2024
: JOHAN LEWIS

Table of Contents

John Lewis Fin Gray Aluminum Metal Pendant light
Parts list
Instructions
Assembly
Care instructions
Specifications
Trouble Shooting:
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

John Lewis Fin Gray Aluminum Metal Pendant light

Thank you for purchasing this Fin Gray Aluminum Pendant light. Please read Assembly the instructions carefully before use to ensure safe and satisfactory operation of this product. Please keep these instructions for future reference.

Warnings!

This product is Class I and must be earthed.
For your safety, this product must be installed in accordance with local Building Regulations. If in any doubt, or where required by law, consult a competent person who is registered with an electrical self-certification scheme. Further Information is available online or from your Local Authority
To prevent electric shock, switch off at the mains supply before installing or Maintaining this fitting. Ensure other persons cannot restore the electricity supply without your knowledge.
If you are in any doubt, please consult a qualified electrician.
If replacing an existing fitting, make a note of the connections.
CAUTION! The LED Model and surrounding parts can become hot during use.

Parts list

2 x wall plugs
1 x cross bar
2 x fixing screws
1 x connector block
2 x grub screws

Instructions

Ensure the house electricity supply is switched off at the fuse board.
Ensure that the bracket (supplied) is fixed to a wooden joist, or use a suitable fixing to the ceiling which will support the weight of the fitting.
Connect cables or terminals as shown below.
Check all wires are tight in the terminal block and no loose strands are left out. Cover with insulating tape (not included)
To adjust the height of the fitting, press centre of the bushes; this will allow the cable to move up and down to the height required.
Push up ceiling cup and secure with metal grub screws.
The maximum power indicated must not be exceeded.
Switch on the electricity supply at the fuse board.

Assembly

Care instructions

We recommend cleaning with a soft dry cloth. Do not use abrasive materials as these will damage the finish.

Indoor use only.
Replace bulbs from John Lewis or established brand of the same type and compatibility.

Recommended LED Light source
1 x 42W
led energy efficient LED MODEL
LED light source included

Specifications

Max. power: 42W
Voltage: 220~240V, 50/60Hz
Weight: 3.2kg

Please retain these instructions for future reference.
This symbol indicates that this product should not be treated as normal household waste and it should be recycled. John Lewis do not operate instore take back, but as members of the Distributor Take Back scheme have funded the development and upgrade of recycling facilities across the UK. Please take it to your nearest collection facility or for further details contact your local council or visit www.recycle-more.co.uk.

We have taken great care to ensure that this product reaches you in perfect condition. However, should any parts be damaged or missing please e-mail lightingparts@JLPspares.co.uk