Johan Lewis Tobias nickel Wall light User Manual
- June 7, 2024
- JOHAN LEWIS
Table of Contents
Johan Lewis Tobias nickel Wall light
Thank you for purchasing this Tobias nickel wall light. Assembly Please read the instructions carefully before use to ensure safe and satisfactory operation of this product. Please keep these instructions for future reference.
Warnings!
This product is Class I and must be earthed.
This fitting should be fitted in accordance with IEE Regulations and the
Building Regulations. If in any doubt, or where required by law, consult a
competent person who is registered with an electrical self-certification
scheme. Further information is available online or from your Local Authority.
To prevent electric shock, switch off at the mains supply before installing or
maintaining this fitting. Ensure other persons cannot restore the electricity
supply without your knowledge.
If you are in any doubt, please consult a qualified electrician. If replacing
an existing fitting, make a note of the connections. Always use the correct
type and power bulb. Never exceed the power stated. When changing a bulb,
always switch off at the mains and allow the old bulb to cool down before
handling. Dispose of used bulbs carefully.
Caution! The bulb and surrounding parts can become hot during use.
Care instructions
We recommend cleaning with a soft dry cloth.
Do not use abrasive materials as these will damage the finish.
Indoors use only.
Replace bulbs from John Lewis or established brand of the same type and
compatibility.
Parts list
Assembly
Ensure the mains electricity supply switched off at the fuse board.
Step 1
Ensure that the bracket (supplied) is fixed to a wooden joist, or use a
suitable fixing to the wall which will support the weight of the fitting.
Step 2
Connect cables or terminals as shown below.
Check all wires are tight in the
terminal block and no loose strands are left out. Cover with insulating tape
(not included)
Step 3
Attach wall light to fixing bracket as shown in the diagram.
Step 4
Attach the correct type and wattage bulb to the lamp holder (bulb not
included). The maximum power indicated must not be exceeded. Switch on the
electricity supply at the fuse board.
References
- John Lewis & Partners | Department Store | Home, Fashion, Tech & More
- 📧lightingparts@JLPspares.co.uk
- Everything you need to know to Recycle More
- Everything you need to know to Recycle More
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>