Johan Lewis Dano Led Wall Light User Manual

: June 7, 2024
: JOHAN LEWIS

Table of Contents

John Lewis Dano LED Wall Light User Manual
Read User Manual Online (PDF format)
Download This Manual (PDF format)

John Lewis Dano LED Wall Light User Manual

Thank you for buying this Dano LED wall light.

Please read the instructions and warnings carefully before use to ensure safe and satisfactory operation of this product.

This product is Class II

Warnings

It is recommended that this fitting is installed by a qualified electrician.
This fitting should be fitted in accordance with IEE Wiring Regulations and the Building Regulations.
To prevent electrocution switch off at the mains supply before installing or maintaining this fitting. Ensure other persons cannot restore the electricity supply without your knowledge.
If you are in doubt please consult a qualified electrician.
To avoid damage to concealed wiring during installation, establish the direction of the supply cable before drilling fixing holes.
This fitting should be fitted to a lighting supply with protected 5 amp fuse or equivalent circuit breaker.
Indicates that the fitting is suitable for mounting on normally flammable surfaces.
Always be sure to use the correct type and wattage of bulbs as indicated on the fitting. Never exceed the wattage stated.
Please note that this fitting incorporates fixed designated LED’s which are non-replaceable and non-dimmable.

Instructions for use

Ensure the house electricity supply is off at the fuse board.
If you are fitting this unit in place of an existing light, you may find that there are more than 3 sets of cables connected within the backplate. Before removing existing fitting, carefully note position of each set of cables.
Remove the mounting bracket from the fitting by undoing the 2 screws located on the side of the backplate.
Using the bracket as a template mark and then drill holes into the wall. Ensure that the holes are drilled into a suitable surface and not just plasterboard. Secure the bracket to the wall using suitable fixings but do not attach the backplate at this point.
Lift the fitting close to supply cable and then make the electrical connections as follows:
Connect supply live (normally brown or red) to fitting live (marked “L”) on the terminal block.
Connect supply neutral (normally blue or black) to fitting neutral (marked “N”) on the terminal block.
Please note: No earth should be connected to any part of this fitting. If any earth wires are present please terminate these in a separate terminal block (not supplied) to ensure that continuity is maintained for the household earth circuit.
Ensure electrical connections are tight and no loose strands of wire are left out of connector block and that the rubber sleeve is correctly located and covering the supply cable. Ensure electrical connections are tight and no loose strands of wire are left out of the connector block.
Secure the backplate to the bracket using the screws removed earlier, ensure that the holes are aligned and no wires are trapped during this process.
Carefully screw the glass shade over the top of the lampholder taking care not to cross-thread or overtighten.
Switch on the electricity supply at the fuse board.