Nedis Bluetooth and noise-cancelling headphones User Manual
- June 7, 2024
- nedis
Table of Contents
Nedis Bluetooth and noise-cancelling headphones User Manual
Description (fig. A)
1. MFB button
|
- Press and hold the button for 3 seconds to switch on the device.
- Press and hold the button for 5 seconds to switch off the device.Press the button to play the track. Press the button again to pause the track.
- Press the button to answer a call.
- Press and hold the button for 1 second to reject a call
- Press the button 2 times to redial the last number.
---|---
2. Volume + button Next button|
- Press the button to increase volume.
- Press and hold the button to go to the next track.
3. Volume – button Previous button|
- Press the button to decrease volume.
- Press and hold the button to go to the previous track.
4. ANC switch|
- Slide the switch to enter noise-cancellation mode.
5. LED indicator (blue / red)|
- Pairing mode: The red and blue LED indicators flash alternately.
- The device is paired: The blue LED indicator flashes once every 3 seconds.
6. LED indicator (red)|
- Charging mode: The red LED indicator is on.
- Charging complete: The red LED indicator goes off.
7. Audio input (3.5 mm jack)|
- **** Connect the audio cable (included) to the audio input and your device.
8. USB port
(Micro USB)
|
- To charge the device, connect the USB cable to the USB ports of the device and the computer or a USB adapter.
Pairing the device
-
Press and hold the MFB button for more than 3 seconds to switch on the device and enter pairing mode. The red and blue LED indicators flash alternately.
Note: If the pairing is not completed within 5 minutes, the device will be automatically switched off. -
Activate Bluetooth on your Bluetooth device.
-
Search for new devices on your Bluetooth device.
-
Select the device “HPBT5260BK / HPBT5260WT “.
-
The device will confirm when the pairing is completed.
Note: If necessary, enter the default password “0000”.
Technical data
Battery type | Lithium-ion battery (300 mAh) |
---|---|
Input voltage (USB charging) | 5V |
Rated power | 10 mW |
Maximum power | 20 mW |
Frequency response | 20 Hz – 20 kHz |
Driver unit | Ø 40 mm |
Signal-to-noise ratio (SNR) | 105 dB / 1 mW |
Playback time (ANC) | ≤ 8 h |
Charging duration | ± 2 h |
Safety
- To reduce risk of electric shock, this product should only be opened by an authorized technician when service is required.
- Disconnect the product from the mains and other equipment if a problem should occur.
- Read the manual carefully before use. Keep the manual for future reference.
- Only use the device for its intended purposes. Do not use the device for other purposes than described in the manual.
- Do not use the device if any part is damaged or defective. If the device is damaged or defective, replace the device immediately.
Cleaning and maintenance
Warning!
- Do not use cleaning solvents or abrasives.
- Do not clean the inside of the device.
- Do not attempt to repair the device. If the device does not operate correctly, replace it with a new device.
- Clean the outside of the device using a soft, damp cloth.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>