AMPROBE INSP-3 Wiring Inspector Tester Instructions
- June 7, 2024
- AMPROBE
Table of Contents
INSP-3
Wiring Inspector Tester
amprobe.com
Designed for use in residential and light commercial environments
The INSP-3, wiring inspector is a rugged tester designed to verify building
wiring compliance to electrical code, especially voltage drop under load.
Identify issues with splices, connections, and conductor quality, crucial to
the safety and performance of the electrical system.
Features
-
Testing efficiency – relevant test data (voltage, voltage drop, hot and neutral voltage drop, voltage with load, ground impedance) is presented on a single large display to save operator time
-
Verifies if wiring is tested for load-carrying ability that it meets electrical code recommendations for voltage drop under load
-
Meter detects faulty wiring in need of repair without removing outlet cover plates or panel covers
– Faulty splices and connections
– Incorrect wiring
– Undersized wiring
– Faulty GFCIs
– Faulty or incorrectly wired AFCIs
– Incorrect line voltage
– Poor ground quality
– Fault currents -
User selectable 0, 10,15, and 20 amps load to verify the performance of the electrical system
-
Incorrect wiring or voltage drop test failure is clearly indicated by flashing screen
-
Will not trip circuit breakers or blow fuses during the test
-
Tests GFCI and AFCI operations
-
Check ground quality for safety and ability to support sensitive electronic equipment
INSP-3
Wiring Inspector Tester
Safety Certification
All Amprobe tools, including the Amprobe INSP-3, are rigorously tested for
safety, accuracy, reliability, and ruggedness in our state-of-the-art test
lab. In addition, Amprobe products that measure electricity are listed by a
3rd party safety lab, either UL or CSA. This system assures that Amprobe
products meet or exceed safety regulations and will perform in a tough,
professional environment for many years to come.
Detects faulty wiring without removing outlet cover plates.
No scrolling or switching screens is needed with the large LCD display.
Verify-in seconds whether a building’s wiring (including voltage drop under load) complies with electrical code.
Specifications
INSP-3
Load| Constant 0, 10, 15, or 20 AMP simulation regardless of line voltage
Operating Voltage| 95-120 VAC
Battery| 9V Alkaline
Fuse| 1/2 Amp, 125 Volt
GFI Trip| 6.0 mA nominal to trip GFI, 30 mA to trip RCD
AFCI Trip| Up to 8, 120 AMP pulses within 1/2 second period
Operating Temperature| 32 ºF to 120 ºF (0 ºC to 50 ºC)
Accuracy| +/-2%, +/- 2 digits
Included: Power cord, 9V alkaline battery (installed), user manual, carrying case
Amprobe® | info@amprobe.com | Fluke Corporation, Everett, WA 98203 | Tel: 877-AMPROBE (267-7623)
©2018 Amprobe® For detailed specifications and ordering go to amprobe.com 3976061 B
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>