BEHA AMPROBE BAT-250-EUR Battery Tester User Manual
- June 4, 2024
- BEHA AMPROBE
Table of Contents
BEHA AMPROBE BAT-250-EUR Battery Tester
Limited Warranty and Limitation of Liability
Your Amprobe product will be free from defects in material and workmanship for one year from the date of purchase unless local laws require otherwise. This warranty does not cover fuses, disposable batteries or damage from accident, neglect, misuse, alteration, contamination, or abnormal conditions of operation or handling. Resellers are not authorized to extend any other warranty on the behalf of Amprobe/Beha-Amprobe. To obtain service during the warranty period, return the product with proof of purchase to an authorized Amprobe/Beha-Amprobe Service Center or to an Amprobe/Beha-Amprobe dealer or distributor. See Repair Section for details. THIS WARRANTY IS YOUR ONLY REMEDY. ALL OTHER WARRANTIES – WHETHER EXPRESS, IMPLIED OR STATUTORY – INCLUDING IMPLIED WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE OR MERCHANTABILITY, ARE HEREBY DISCLAIMED. MANUFACTURER SHALL NOT BE LIABLE FOR ANY SPECIAL, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES OR LOSSES, ARISING FROM ANY CAUSE OR THEORY. Since some states or countries do not allow the exclusion or limitation of an implied warranty or of incidental or consequential damages, this limitation of liability may not apply to you.
Repair
All test tools returned for warranty or non-warranty repair or for the
calibration should be accompanied by the following: your name, company’s name,
address, telephone number, and proof of purchase. Additionally, please include
a brief description of the problem or the service requested and include the
test leads with the meter. Non-warranty repair or replacement charges should
be remitted in the form of a check, a money order, a credit card with an
expiration date, or a purchase order made payable to Amprobe/Beha-Amprobe.
In-Warranty Repairs and Replacement – All Countries
Please read the warranty statement and check your battery before requesting
repair. During the warranty period, any defective test tool can be returned to
your Amprobe/Beha-Amprobe distributor for an exchange for the same or like the
product.
Non-warranty Repairs and Replacement – the United States and Canada
Non-warranty repairs in the United States and Canada should be sent to an
Amprobe Service Center. Call Amprobe or inquire at your point of purchase for
current repair and replacement rates.
USA:
Amprobe Everett, WA 98203
Tel: 877-AMPROBE (267-7623)
Canada:
Amprobe Mississauga, ON L4Z 1X9
Tel: 905-890-7600
Non-Warranty Repairs and Replacement – Europe
European non-warranty units can be replaced by your Beha-Amprobe distributor
for a nominal charge. Please check the “Where to Buy” section on beha-
amprobe.com for a list of distributors near you. European Correspondence
Address: Beha-Amprobe® Beha-Amprobe GmbH In den Engematten 14 79286
Glottertal, Germany
Tel.: +49 (0) 7684 8009 – 0
(Correspondence only – no repair or replacement available from this address.
European customers please contact your distributor.)
BAT-250-EUR Battery Tester
- Battery condition display
- 1.5 V battery test terminal
- 9 V battery test terminal
SYMBOLS
WARNING and PRECAUTIONS
- Do not operate this instrument in the presence of gasoline, natural gas, propane, or in other combustible atmospheres.
- The BAT-250-EUR is intended to indicate general battery condition and will not predict remaining battery life.
- Test only ONE battery at a time.
- For indoor use only. Do not modify or disassemble.
- To verify the battery tester’s operation, first test on a new, fully charged battery. Keep test time as short as possible to avoid unnecessary battery drain.
OPERATION
Reading The Meter
Red
| REPLACE: Battery is weak and should be replaced.
---|---
Yellow
| LOW: Limited power left in the battery. Replacement is recommended.
Green
| GOOD: Battery is fully charged with adequate power.
Caution
- Insert a new battery in the Tester to ensure accurate operation before battery tests.
- To test the battery, note the polarity sign marked in the Tester then hold the battery as appropriate (see examples at right).
Testing Batteries
Testing capability (battery sizes): 9 V, AAA, AA, C, D and 1.5 V button/coin/watch battery.
Visit beha-amprobe.com for
- Catalog
- Application notes
- Product specifications
- User manuals
Beha-Amprobe® beha-amprobe.com In den Engematten 14
79286 Glottertal, Germany
Tel.: +49 (0) 7684 8009 – 0
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>