Merchsource 1015211 Car Phone Mount Air Vent with Wireless Charging User Manual
- June 6, 2024
- MerchSource
Table of Contents
WIRELESS CHARGING CAR PHONE MOUNT
CONTENTS
- Mount
- USB Cable
- USB Car Adapter
SPECIFICATIONS OF MOUNT
- Input: DC 5V/2A (Max)
- Output: 5W
- Wireless Charging Version: Qi 1.2.4
SPECIFICATIONS OF USB CAR ADAPTER
- Input: DC 12V-24V
- Output: DC 5V/2.1A (Max)
COMPATIBILITY
- iPhone 8 series, iPhone X series, Samsung Galaxy S8/S9/S10 Series, Samsung Galaxy Note 8/9 Series
- Qi wireless technology enabled devices
- Non-metal phone cases up to 3 mm thick
WARNING: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
- This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
- Caution: To maintain compliance with the FCC’s RF exposure guideline, place the Wireless Charging Stand at least 20 cm from nearby persons.
LAYOUT
SAFETY WARNINGS: PLEASE READ ALL SAFETY WARNINGS AND INSTRUCTIONS BEFORE USE
- Not a children’s item. Keep out of reach of children.
- Always obey all local, state, and federal driving laws.
- Always ensure the mount is properly installed prior to use and before starting to drive.
- Always ensure the phone is securely set in the mount prior to use and before starting to drive.
- Be aware of vent temperature. High vent heat may damage phones.
- Use this item only for its intended purpose.
- Do not expose to extreme temperatures or moisture.
- Thoroughly inspect products before every use. If the product appears worn, frayed/splintered, cracked, or broken in any manner, discontinue use and discard immediately.
INSTALLING YOUR MOUNT
- Loosen the adjustment knob.
- Hold down the vent clip button and slide the vent clip onto your car’s vent as far back as possible. Some vents such as round vents may require extra care for stable mounting.
- Tighten the adjustment knob. Do not overtighten.
- Test the vent clip’s connection for stability before continuing.
- Once securely mounted, plug one end of the Micro USB cable into the car adapter and the other side to the mount.
MOUNTING YOUR PHONE
- Make sure the mount is secure before installing your device.
- Extend the mount’s arms and then place your device in the cradle and carefully release the arms so they adjust to the width of your device.
- Pressure will hold your device in place. Make sure your device is secure before letting go.
- If your device is equipped with Qi wireless charging, then the LED indicator ring will light up blue to indicate it is charging.
• Red LED – mount is powered and ready for charging
• Blue LED – the device is successfully charging
REMOVING YOUR PHONE
- Hold your device and then extend the arms
TROUBLESHOOTING
- Device is not charging – Make sure your device’s wireless charging coil is centered with the center of the mount.
- No power to mount – make sure the USB cable is plugged into the mount and into a USB adapter. Make sure the USB adapter is receiving power.
This product is meant for use only in conjunction with a suitable device.
Please consult your device packaging to determine whether this product is
compatible with your particular device. The manufacturer is not responsible
for any damages to any device or personal property incurred through the use of
this product.
The manufacturer shall in no way be liable to you or to any third party for
any damages you or any third party may suffer as a result of use, intended or
unintended, or misuse of this product in conjunction with any device or
accessory other than the compatible device for which this product is designed
or intended. The manufacturer will not be responsible for any damages you or
any third party may suffer as a result of misuse of this product as outlined
above. Samsung and Galaxy S are both registered trademarks of Samsung
Electronics Co., Ltd. Apple and iPhone are trademarks of Apple Inc. Qi is a
trademark of the Wireless Power Consortium.
© 2019 MerchSource, LLC. Irvine, CA 92618. All rights reserved.
For technical support, please call
1-800-374-2744.
KEEP THIS INSTRUCTION MANUAL AS IT CONTAINS IMPORTANT
INFORMATION FOR FUTURE REFERENCE.
Due to continuous product improvements, the picture on the manual may
differ slightly from the actual product.
Model: 1015211
Printed in China.
Documents / Resources
|
Merchsource 1015211 Car Phone Mount Air Vent with Wireless
Charging
[pdf] User Manual
1015211, 2AEVM1015211, 1015211 Car Phone Mount Air Vent with Wireless
Charging, Car Phone Mount Air Vent with Wireless Charging, Wireless Charging,
Car Phone Mount Air Vent, Air Vent
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>