ALCAD MVC-141 Videodoor Entry System Monitor User Manual

: June 11, 2024
: ALCAD

Table of Contents

MECHANICAL ASSEMBLY
CONNECTING INSTRUCTIONS
SEVERAL MONITORS IN THE SAME APARTMENT
PROGRAMMING INSTRUCTIONS
TECHNICAL CHARACTERISTICS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

ALCAD MVC-141 Videodoor Entry System Monitor User Manual

2-WIRE VIDEODOOR ENTRY SYSTEMS

VIDEODOOR ENTRY SYSTEM MONITOR

MECHANICAL ASSEMBLY

Recommendations

When deciding where to position the connection support, choose an area of Wall which is smooth, even and hard. Bear in mind the dimensions of the monitor, ensuring that you leave space enough on the right-hand side of the bracket (>70 mm) to be able to Access the controls on the monitor. Avoid places where there are sources of direct light, thereby preventing undesired or steam, which could reduce the operational life of the equipment.

Monitor and bracket size

Installing instructions

ALCAD MVC-141 Videodoor Entry System Monitor - Installing
instructions

CONNECTING INSTRUCTIONS

ALCAD MVC-141 Videodoor Entry System Monitor - CONNECTING INSTRUCTIONS
1

SEVERAL MONITORS IN THE SAME APARTMENT

Connect all monitors in the house.
Program the monitors one by one and with the same button / code, see “Programming instructions” Page 15
The monitor programmed in the first place will be the main monitor.

ALCAD MVC-141 Videodoor Entry System Monitor - SEVERAL MONITORS IN THE SAME
APARTMENT

Functioning

Received the call in the apartment, it sounds on all monitors. The visitor’s image apartment. Possibility of displaying the image on the other monitors without having to pick up the receiver, by pressing the auto-switch on button . You can answer the call from any of the monitors by pressing the communication button. Once the communication is established from one of the monitors, it will not be possible to pick up from any other, keeping the secret of the communication at all times.

PROGRAMMING INSTRUCTIONS

The programming of the monitor must be done from the main entrance panel of the system (See the corresponding installation manual).

The button / programming code is stored in the monitor. If the monitor is replaced, do not forget to program it.

For installations with several devices (telephones or monitors) in the same home, program all the devices one by one and with the same button / code.

Programming steps

Move the PROG switch to the OFF position; Return the switch to the ON position.
Press the door open button . The audio will be activated between the monitor and the main entrance panel.
Located on the main street panel, make the call to the apartment where the monitor to be programmed is located. The entrance panel will emit a confirmation beep, the monitor has been programmed.

Note : Once the monitor is programmed, make sure that the PROG switch is in the ON position.

Note : Maximum time of 1 minute between steps 1,2 and 3. After the maximum time you must start programming from step 1.