SUPERATV Honda Talon Door Inserts Installation Guide

June 7, 2024
SUPERATV

SUPERATV Honda Talon Door ISUPERATV Honda Talon Door
Inserts

2753 Michigan Road · Madison, Indiana 47250 ·855-743-3427
INSTALLATION INSTRUCTIONS
Door Inserts: for Honda Talon

SUPERATV Honda Talon Door Left Door

Liability Statement

SuperATV’s® products are designed to best fit users ‘ ATV/UTV under stock conditions. Adding, modifying, or fabricating any factory or aftermarket parts will void any warranty provided by SuperATV® and is not recommended. SuperATV’s® products could interfere with other aftermarket accessories. If the user has aftermarket products on the machine, contact SuperATV® to verify that they will work together.
Although SuperATV® has thousands of satisfied customers, users should be aware that installing lift kits, long travel, or suspension kits, tires, etc. will change the ride of the machine and may increase maintenance and part wear. Operating any off-road machine while, or after, consuming alcohol and/or drugs increases the risk of bodily harm or death. No warranty or representation is made as to this product’s ability to protect users from severe injury or death. SuperATV® urges operators and occupants to wear a helmet and appropriate riding gear at all times.
By purchasing and installing SuperATV® products, the user agrees that should damage occur, SuperATV® will not be held responsible for loss of time, use, labor fees, replacement parts, or freight charges. SuperATV®, nor any 3rd party, will not be held responsible for any direct, indirect, incidental, special, or consequential damages that result from any product purchased from SuperATV®. The total liability of the seller to the user for all damages, losses, and causes of action, if any, shall not exceed the total purchase price paid for the product that gave rise to the claim.
SuperATV® will warranty only parts provided by SuperATV®. Any damage or problems with OEM housings, bearings, seals, or other manufacturers’ products will not be covered by SuperATV®. SuperATV® parts and products are not warrantied if item was not installed properly, misused, or modified.
Installing, adding, modifying, or fabricating any factory or aftermarket product to your ATV/UTV may violate certain local, state, and federal laws. Be advised that laws vary depending on town, city, county, state, etc. Use of certain products on public streets, roads, or highways may be in violation of the law. The Buyer is solely and exclusively legally and personally responsible for any violation of the law by the installation or use of the product. You must abide by all local, state, and federal laws, including but not limited to vehicle safety, traffic laws, and ordinances. It is your responsibility to know the laws and how they apply to you.
The Buyer is responsible to fully understand the capability and limitations of his/her vehicle according to manufacturer specifications, warnings and instructions and agrees to hold SuperATV® harmless from any damage resulting from failure to adhere to such specifications, warnings, and/ or instructions. The Buyer is also responsible to obey all applicable federal, state, and local laws and ordinances when operating his/her vehicle while using this product, and the Buyer agrees to hold SuperATV® harmless from any violation thereof.

♦Remove (8) screws from locations shown.

SUPERATV Honda Talon Door Locate stock indentations

♦Locate stock indentations in areas shown and drill out to Ø9/32”.

SUPERATV Honda Talon shown and drill 1 repeat steps for opposite Door

♦Temporarily install the Right Bracket with the hardware shown.

SUPERATV Honda Talon DoorTemporarily install Right
Bracket

♦Locate (3) holes in the Right Bracket and mark locations onto stock plastic.
♦Remove Right Bracket.
♦ Drill holes to Ø9/32”.
♦ Reinstall Right Bracket.

♦ Secure Right Bracket to stock plastic with hardware shown; tighten hardware completely.

SUPERATV Honda Talon Door IshownSecure Right Bracket

♦ Install Right Door to Right Bracket with hardware shown; tighten hardware completely.SUPERATV Honda Talon Door align hardwareSUPERATV Honda Talon Door n
Bracket

“Seal Installation”
To ease installation, soak Seal in hot water before cutting or installing to increase flexibility.

SUPERATV Honda Talon Door Bulb Seal

Reinstall stock Insert, tighten hardware completely, and repeat steps for the opposite side.

SUPERATV Honda Talon Door BulbReinstall stock Insert

Read instructions and view illustrations before beginning.SUPERATV Honda
Talon Door Inserts logo

Need help with your installation?

sales@superatv.com

|

www.superatv.com

---|---

1-855-743-3427

| 8:00am – 8:00pm EST M-Th
8:00am – 7:00pm EST Friday
9:00am – 2:00pm EST Saturday

© 2021 SuperATV.com. All Rights Reserved.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

SUPERATV User Manuals

Related Manuals