PET GEAR Indoor Outdoor Carpeted BI-Fold Pet Ramp Instruction Manual
- June 7, 2024
- PET GEAR
Table of Contents
PET GEAR Indoor Outdoor Carpeted BI-Fold Pet Ramp
PARTS LIST
Check that you have all the parts shown BEFORE assembling your product.
If any parts are missing, call Customer Service.
INSTRUCTIONS FOR USE
Step 1. Unfold ramp and place on firm surface with carpet surface facing
up (Figure A).
Watch for pinch points while unfolding
ramp (Figure B).
Step 2. Be sure the ramp is
secure and all four corners are supported.
Step 3. If used on the rear entrance of a van or SUV, attach the security
strap to the floor door latch, as shown (Figure C).
FABRIC CARE
The carpet tread removes easily and is machine washable in gentle detergent.
WARNING!
- Before use, be sure ramp is installed according to instructions.
- Use as a pet ramp ONLY!
- Do not use to load people or other objects.
- Never leave the ramp unattended.
- The ramp is designed to support a maximum load of 150 lbs. when installed properly.
- Exceeding the load limit will void the product warranty and may cause injury to the pet or pet owner.
- Never use the ramp while the vehicle is in motion.
FOR PETS ONLY.
Not intended to be used as a restraining device for aggressive or dangerous
animals that dig, chew or paw aggressively. Do not leave your pet unattended.
PET GEAR is not liable for any damage caused by aggressive, destructive,
immature or untrained animals. Do not use near an open or exposed flame.
Failure to follow these warnings and the instructions could result in serious
injury or death.
REPLACEMENT PARTS
Use only PET GEAR replacement parts.
Please have your model number ready before calling.
You can also request parts: http://www.petgearinc.com/main.asp?sel=2