BLAUPUNKT Tire Pressure Monitoring System User Guide
- June 7, 2024
- Blaupunkt
Table of Contents
TIRE PRESSURE
MONITORING SYSTEM
TPMS 3.0
Enjoy it.
Operating and Installation Instructions
CAUTIONS
Safety Notes
This TPMS (Tire Pressure Monitoring System) has been manufactured according to
established safety guidelines. However, dangers may still occur if the safety
notes in this manual is not observed. This manual is intended to familiarize
the user with the TPMS’s important functions. Read this carefully, prior to
using the appliance. Keep this manual in an easily accessible location. In
addition, do observe the instructions of the devices used in conjunction with
this appliance.
Road Safety
Always observe the following notes for road safety:
- Device must be used in a way that compliments the safety of the user when driving the vehicle. It is recommended for the user to park at an appropriate location when examining the tires in case of abnormal alert.
General Safety
- Device is intended for installation and operation in a vehicle with 12V vehicle system outage, hence the device must be installed 300mm away from the head unit to prevent signal disruption.
- Do not dismantle or modify the device. Installation or repair should be performed by a specialist. Blaupunkt is not liable for any loss or damage resulting from unauthorized disassembly or modification to the device.
- Device is compatible with car radios with rear camera input.
- Device is designed to monitor tire pressure and temperature only. Driver is responsible for the upkeep of the tires.
- Blaupunkt is not liable in case of loss of sensors. Contact your Blaupunkt dealer to purchase new sensors.
- Package comes with pre-set sensor for designated tires. In case of sensor replacement or change of sensor location, ensure the sensor are reprogrammed before operating.
- Please do not operate the device under such conditions (extremely high temperature or extremely low temperature); ensure that the temperature within the car ranges from -20°C to 80°C before you begin installation process and during operation.
- For abnormalities, please refer to the “Troubleshooting” section. Consult with Blaupunkt dealer for further examining, in case if the problem cannot be resolved.
This manual may be updated from time to time without any notice.
Disclaimer
In no event shall Blaupunkt be liable for any direct, indirect, punitive,
incidental, special consequential damages to property or life and whatsoever
arising out of or connected with the use or misuse of our products. USA &
CANADA: This product is not intended for sale in the United States and Canada.
If purchased in the U.S. or Canada, this product is purchased on as-is basis.
No warranty, whether expressed or implied is provided in the U.S. or Canada.
STRUCTURE & FUNCTIONS
Functions
| 1. Receiver | 4. Battery | 7. Washer |
|---|---|---|
| 2. Remote Button (Battery Included) | 5. Sensor (Battery Included) | 8. Hex |
Nut
3. Sensor Cover| 6. Rubber Seal|
SPECIFICATIONS
Sensor
Operating frequency| 433.92 ± 0.05MHz
Battery voltage| 2.2V ~ 3.3V
Battery lifetime| 1-year
Operating temperature| -20°C ~ 70°C
Pressure range| 0~3.5 Bar / 0~50 PSI
Receiver
Operating current| <200mA
Operating frequency| 433.92± 0.05MHz
Operating voltage| +12V
Operating temperature| -20°C ~ 70°C
Default Value
High pressure value| 3.0 Bar / 43 PSI
Low-pressure value| 1.8 Bar / 26 PSI
High-temperature value| 68°C
Precision
Temperature| +/-2°C
Pressure| 0.1 Bar / 1.5 PSI
Air pressure unit| 1 Bar = 14.5 PSI = 100 Kpa = 1.02Kgf/cm2
Accessories
TROUBLESHOOTING
If any of the following problem occur, please resort to Troubleshooting for the possible solutions. Consult Blaupunkt authorized dealer if problem persist.
| Problems | Solutions |
|---|---|
| Air leakage after sensor installation | The tire valves may not be universal |
standard, please check with the local workshop.
No tire data are displayed after completing installation| Ensure ACC is turned
on.
Missing or lost sensor| Please purchase new sensor.
Sensor battery low| Please replace with battery CR1632.
Change of tire location| Please reprogram the corresponding sensors.
RECEIVER INSTALLATION WIRING DIAGRAM
SENSOR INSTALLATION
SENSOR BATTERY REPLACEMENT
OPERATION INSTRUCTION
DIFFERENT SCENARIO
https://www.facebook.com/blaupunkt.asia
Designed and engineered by Blaupunkt Competence Centre
1 311 19 003 23 01
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>