Member’s Mark Painted Porch Swing Instruction Manual

Member's Mark Painted Porch Swing Instruction Manual

We are so confident you will be delighted with your Member’s Mark purchase that we promise to refund or replace any item you find unsatisfactory. we are to delight all our members and would love to hear about your discoveries call us at : 1-888-301-0332 (toll-free), 8am – 5pm CST Monday – Friday Call center for missing parts: 1-888-287-4275 from 9.00 am to 5.00 pm CST (Monday to Friday)

Important Safety Information

• Please read all instructions carefully before assembling this furniture.
• For your safety, assembly by two or more adults is strongly recommended.
• Use only vendor-supplied hardware to assemble this item. Using unauthorized hardware could jeopardize the structural integrity of the item.
• Hardware may loosen overtime. Periodically check that all connections are tight.

Before Assembly

• Remove all parts and hardware from the box. Place all items on a carpeted or scratch-free work surface, as this will avoid damaging parts during assembly.
• The shipping box provides an ideal work surface.
• To avoid accidentally discarding small parts or hardware, do not dispose of any packaging or contents of the shipping carton until assembly is complete.
• Use the parts and hardware lists below to identify and separate each of the pieces included.
• The use of power tools tor assembly is not recommended. Power tools can damage the hardware and/or split the wood.
• Note: Do not fully tighten all bolts unit all parts are in place. Failure to follow these instructions may cause the bolts to misalign during assembly.

WARNING-T·O AVOID RISK OF FALLING

• WEIGHT LIMIT 500 LBS MAXIMUM.
• Swing is intended to be used by two persons at a time.
• Swing must be used with all provided parts. Ensure that all parts are installed according to instructions and inspected for damage before use.
• Ensure that all bolts and hardware are securely tightened and installed before use.
• Never place infants or pets in the chair.
• Never allow young children to use chair without adult supervision.
• Do not jump, stand, or twist in chair.
• Swing are designed for minimal swing motion. Use care when getting in and out of swing.

Component

Al … Right side frame …1 Pc
A2 … Left side frame…1 Pc
B …Back support … 1 Pc
C… Seat … 1 Pc
D …  Front apron …1 Pc

Hardware

Tools Needed for Assembly

Install on level ground. Attach the right side frame (Al) into back support (D). Secure with 2″ bolts (E). Do not tighten the bolts yet.

Next, attach the seat (C) into predrilled holes of back support (8).

Attach the front apron (D) into seat (C) and right side frame (Al). Secure using 2″ bolt (E). Next, attach the left side frame (A2) into back support (B) and front apron (D). Secure using 2″ bolts (E).

Secure the seat (C) using 2″ screws (F) and 1″ screws (G) as shown. Next, tighten all bolts completely using screwdriver before tapping in the wooden caps (M).

Secure the hanger bolts with chain (H) into predrilled holes of the right side frame (A 1) using washers (J), nuts (K), and head nuts (L) as shown. (The hanger bolts with long chain must be install in front).Repeat the same procedure to install the hanger bolts (H) into the left side frame (A2).
make sure all parts are correctly connected and tighten all nuts completely using wrench

NOTICE:
Install not less than 6 feet from any obstruction such as fence, garage, house, overhanging branch laundry lines or electrical wires.

To hang up the swing :
Drill pilot holes on your swing frame/overhead beam of your porch, at the width of 65 inch.
Insert the hanger bolt (I) into predrilled holes of swing frame and secure with washers (J) and nut (M) as shown. Tighten the nuts using wrench.

Once the hanging bolt (!) are in place, attach a chain lock (provided in the chain kit “H”) to the hanging bolt (I) by open the thread. Then tighten the chain lock manually.

Repeat the same procedure to install the other side.

Adjust the swing height for comfortable. Recommended height is 23.5 inch from the bottom of the seat to the ground.

THE SWING IS NOW READY FOR USE.

MAINTENANCE

Wood is a living material that continues to respond to climate condition even after being made into a piece of furniture.

After assembly rub the furniture with soft rag to remove any residual dust. Wood is a natural material whose appearance will change when left outdoors. This product has been treated prior to leaving the factory. To clean, use mild soap and warm water. Do not use abrasive material, cleansers or bleach products, Dry thoroughly with soft cloth,

Even though this piece of furniture is extremely durable and long lasting, to prolong life we recommend bringing it indoors during freezing temperatures. Place it at a shaded area and do not leave it in standing water or on wet ground.

Do not put hot items directly on furniture surface.

Do not store furniture in areas that have central heating or cooling vents to prevent excessive drying of the wood. This will decrease the furniture’s. longevity.

Do not write on furniture without a padded barrier to protect the surface.

In order to maintain the product’s durability, please read carefully.

Do not leave your furniture in puddles of water or on wet ground.
Cover your furniture during winter months or move into covered storage, if in wet climates.
The manufacturer supports protection of the world’s forest: resources and is diligent is sourcing legally harvested wood.
Thank you
The manufacturer

Need assistance? Call us at 1-888-301-0332 from 8am to 5pm CST Monday – Friday

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>