Honeywell Portable Single Gas Detector User Manual
- June 7, 2024
- Honeywell
Table of Contents
Gas Detection
Quick Reference Guide
Honeywell BW ™ Solo
Portable Single gas Detector
©2020, Oct 23 G05-4001-000-RevC
Overview
Contact Us
Europe, Middle East, Africa
Life Safety Distribution GmbH
Toll-Free 00800 333 222 44
Middle East +971 4 450 5800
Middle East +971 4 450 5852
(Portable Gas Detection)
gasdetection@honeywell.com
Americas
Honeywell Analytics
Distribution Inc.
Tel: +1 847 955 8200
Toll free: +1 800 538 0363
detectgas@honeywell.com
Asia Pacific
Honeywell Analytics Asia Pacific
Tel: +82 (0) 2 6909 0300
India Tel: +91 124 4752700
analytics.ap@honeywell.com
Technical Services
EMEA: HAexpert@honeywell.com
US: ha.us.service@honeywell.com
AP: ha.ap.service@honeywell.com
www.honeywellanalytics.com
https://www.honeywellanalytics.com/en/products/BW-Solo
Safety Certifications
Wireless Approvals
FCC ID: SU3BWS1
IC: 20969-BWS1
RED: RE-D Directive 2014/53/EU
IP Rating
IP66; IP68 1.2 meters for 45 minutes
Honeywell BW Solo is designed to operate via Bluetooth Low Energy to send data to a smartphone running Safety Communicator. The data can then be sent to computers running ProRAE Guardian monitoring software.
WARNINGS
– For safety reasons, this equipment must be operated and serviced by
qualified personnel only.
– Read and understand the instruction manual completely before operating or
servicing.
– Substitution of components may impact safety.
– Lithium battery: Only use approved battery: 2/3AA 3.6V 1.65Ah Lithium
battery (P/N: 500-0160-000).
CAUTION
– To reduce the risk of electric shock, turn the power off before opening
this instrument or performing service.
– Never operate the instrument when the instrument is open.
– Service this product only in an area known to be non-hazardous.
– Recycling: this instrument contains a lithium battery. Do not mix with the
solid waste stream. Spent batteries should be disposed of by a qualified
recycler or hazardous
materials handler.
– This device complies with Part 15 of the FCC Rules / Industry Canada
license-exempt RSS standard(s). Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Common device’s operations
| Power On | 5-second hold |
|---|---|
| Power Off | 5-second hold |
| Enter Menus | Double-click |
| Select Next | Single-click |
| Initiate Selected | Long Hold |
IMPORTANT: Read the User Guide for complete information on the BW Solo operation.
Bump Test/Configuration
-
Press twice repeteadily.
-
Select Bump Test or Configuration, and then follow On-screen instructions until ‘‘Apply Gas?” is displayed.
-
Place the calibration cap over the Honeywell BW Solo, and then hook the cap’s left clip to the corresponding groove of the detector.
-
Press down on the tab to snap the right clip into place.
-
Attach hose and open the cylinder valve by turning the pressure regulator knob counterclockwise.
-
Remove the calibration cap by pulling on the tab.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>