REXTON Bi-Core C R-Li Hearing Aid User Guide
- June 7, 2024
- REXTON
Table of Contents
Bi-Core
C R-Li
Quick Start Guide
This is not a substitution for reading your Owner’s Manual.
For more in-depth instructions, please refer to your Owner’s Manual.
- Charge your hearing aids:
Insert as shown in picture until LED blinks green
LED Status description
No LED: charger not connected to power supply or charger turned off
Blinking green LEDs: charging
Solid Green LEDs: charge completely if the charger is connected to a
power outlet
2. Turn your hearing aids on
- Your hearing aids turn on automatically when removed from the charger
- They are programmed to have a start-up delay to allow you to insert without whistling
- You will hear a melody during the start-up
6 Second 12 Second 18 Second
3. Insert your hearing aids
-
Grasp receiver/dome between your thumb and forefinger
– Insert dome into your ear canal
– Gently work the dome into proper position by slightly adjusting it until it is firmly seated in your ear -
Lift the hearing aid over the top of your ear
− Adjust it to fit behind your ear
− Press slightly for a secure and comfortable fit
− Place retention strand into the bottom “bowl” of your ear (if applicable)
4. Using your hearing aids
- Your hearing aids feature Wireless Sync, which automatically adjusts both hearings aid simultaneously to reflect changes in your hearing environment
- The rocker switch to control on your hearing aids may be programmed to give you personal control of your hearing aids
- The functions for short and medium press will change both hearings aids simultaneously.
| Your controls | Press |
|---|---|
| Short (1 second) | Medium (2 seconds) |
L R
| L R|
L R
Volume Up/Down|
|
|
Program Up/Down|
|
|
TV Stream|
|
|
Power On/Off|
–
| –|
Press and hold until hearing aid turns on/off
Your hearing aids may be programmed to alert you when you are making changes to your hearing aids or when your battery needs replacing.
Signal tones
|
L R
Program Change|
Volume Change|
Volume Limit|
Volume On Position|
Low Battery|
Bluetooth On/Off|
Power On/Off|
Troubleshooting
Problem & possible solutions
Sound is weak:
Increase the volume
Recharge the hearing aid
Clean or exchange the dome or wax protector
Hearing aid emits whistling sounds:
Reinsert the receiver until it fits securely
Decrease the volume
Clean or exchange the dome or wax protector
Sound is distorted:
Decrease the volume
Recharge the hearing aid
Clean or exchange the dome or wax protector
Hearing instrument emits spontaneous signal tones:
Recharge the hearing aid
Hearing aid does not work:
Turn the hearing aid on
Recharge the hearing aid
Power-on-delay is active. Wait several seconds and check again
Clean or exchange the dome or wax protector
Consult your Hearing Care Professional if you have further problems
© Rexton, a Division of WSAUD A/S. All rights reserved. 10980917 5/21 1.0
V11011083 SIV-10494
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>