REXTON M-Core R-Li Hearing Aids User Guide
- June 6, 2024
- REXTON
Table of Contents
REXTON M-Core R-Li Hearing Aids User Guide
Quick Start Guide
This is not a substitution for reading your Owner’s Manual. For more in depth instructions, please refer to your Owner’s Manual.
-
Check the charging status of your hearing aid
** LED| Status description**
---|---
| Orange LED: Charging status 0 to 33 %
| Single green LED: Charging status 34 to 66 %
| Two green LEDs: Charging status 67 to 99 %
| Three green LEDs: Hearing instrument is fully charged -
Turn your hearing aids on
- Your hearing aids turn on automatically when removed from the charger.
- They are programmed to have a start-up delay to allow you to insert without whistling.
- You will hear a melody during the start-up.
- 6 Second****
- 12 Second****
- 18 Second
-
Insert your hearing aids
- Grasp receiver/dome between your thumb and forefinger
- Insert dome into your ear canal
- Gently work dome into proper position by slightly adjusting it until it is firmly seated in your ear
- Lift the hearing aid over the top of your ear
- Adjust it to fit behind your ear
- Press slightly for a secure and comfortable fit
- Place retention strand into the bottom “bowl” of your ear (if applicable)
-
Using your hearing aids
- Your hearing aids feature Wireless Sync, which automatically adjusts both hearing aids simultaneously to reflect changes in your hearing environment
- The rocker switch control on your hearing aids may be programmed to give you personal control of your hearing aids
- The functions for short and medium press will change both hearing aids simultaneously.
Your controls
| Your controls
---|---
| Short (1 second)| Medium (2 seconds)|
**Hold***
| | | **
Volume Up/Down**| | |
–
Program Up/Down
| | | –
TV Stream| | |
–
Power On/Off
| –| –|
Press and hold until hearing aid turns on/off
Your hearing aids may be programmed to alert you when you are making
changes to your hearing aids or when your battery needs replacing
Signal tones
| ****
Program Change
|
Volume Change
|
Volume Limit|
Volume On Position
|
Low Battery|
Bluetooth On/Off
|
Power On/Off|
Troubleshooting
Problem & possible solutions
Sound is weak:
Increase the volume
Recharge the hearing aid
Clean or exchange the click dome or wax protector
Hearing aid emits whistling sounds:
Reinsert the receiver until it fits securely
Decrease the volume
Clean or exchange the click dome or wax protector
Sound is distorted:
Decrease the volume
Recharge the hearing aid
Clean or exchange the click dome or wax protector
Hearing instrument emits spontaneous signal tones:
Recharge the hearing aid
Hearing aid does not work:
Turn the hearing aid on
Recharge the hearing aid
Power-on-delay is active. Wait several seconds and check again
Clean or exchange the click dome or wax protector
Consult your Hearing Care Professional if you have further problems
© Rexton, a Division of WSAUD A/S. All rights reserved. 10980917 6/20 2.0 V11011083 SIV-7465
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>