Custom Dynamics CD-STTL-HARN Low Rider Integrated Taillight Harness Installation Guide
- June 3, 2024
- Custom Dynamics
Table of Contents
Custom Dynamics CD-STTL-HARN Low Rider Integrated Taillight Harness
We thank you for purchasing the Custom Dynamics® Low Rider Integrated Harness. Our products utilize the latest technology and high-quality components to ensure you the most reliable service. We offer one of the best warranty programs in the industry and we back our products with excellent customer support, if you have questions before or during the installation of this product please call Custom Dynamics® at 1(800) 382-1388.
Part Numbers: CD-STTL-HAR
Package Contents
- Low Rider Integrated Taillight Harness (1)
- Magnetic Wire Tie Holder (10)
- 4” Wire Tie (12)
Fits: 2018 – 2022 Harley-Davidson® Low Rider® (FXLR), Low Rider® S (FXLRS) and Low Rider® ST (FXLRST) with Custom Dynamics® Integrated Taillight Assembly (Sold Separately).
ATTENTION
Please read all information below before the Installation
Warning: Disconnect the negative battery cable from the battery; refer to the owner’s manual. Failure to do so may result in electrical shock, injury, or fire. Secure the negative battery cable away from the positive side of the battery and all other positive voltage sources on the vehicle.
Safety First: Always wear appropriate safety gear including safety
glasses when performing any electrical work. It is highly recommended that
safety glasses be worn throughout this installation process. Be sure the
vehicle is on a level surface, secure, and cool.
Important: This product is designed and intended for use as auxiliary
lighting only. It is NOT intended to replace any original equipment lighting
installed on the vehicle and should not be used for that purpose. This product
must be wired so that it does not interfere with any original equipment
lighting.
Installation
- Secure the motorcycle on a level surface. Confirm the ignition switch is in the off position.
- Remove the seat and locate the rear lighting connectors to the rear fender as shown in Picture 1.
- Plug the Low Rider Integrated Taillight Harness into the rear turn signal lighting connectors shown in Picture 1. The Low Rider Integrated Taillight Harness JAE turn signal connectors with the brown wire will connect to the Black JAE connectors of the bikes wiring harness. The Low Rider Integrated Taillight Harness JAE turn signal connectors with the Purple wire will connect to the Gray JAE connectors of the bike’s wiring harness as shown in Picture 2.
- Route the Low Rider Integrated Taillight Harness through the rear fender to the taillight mounting base.
- Using the provided Magnet Wire Tie Holders and Wire Ties, secure the harness to the underside of the rear fender. Make sure the harness will not come in contact with the rear tire while operating the motorcycle.
- Connect the Low Rider Integrated Taillight Harness to 2 pin Female Connector with the Purple wire to the integrated taillight 2-pin Male turn signal connector with the Purple wire. Connect the Low Rider Integrated Taillight Harness to 2 pin Female Connector with the Brown wire to the integrated taillight 2-pin Male turn signal connector with the Brown wire. The 2 pin Female connectors on the Integrated taillight will not be used. Refer to Photo 2.
- Install the taillight on the taillight base.
- Perform a BCM sync by turning the ignition on, turning the 4-way hazards on, turn the ignition off. Allow the 4-way hazards to run for 3-4 minutes. Turn the ignition on. Turn the 4-way hazards off. Turn the ignition off.
- Test all lighting for proper operation before riding.
Questions? Call us at: 1 800-382-1388 M-TH 8:30 AM-5:30 PM / FR 9:30 AM-5:30 PM EST
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>