GRIVITY 10W Wireless Charging Power Bank User Manual
- June 7, 2024
- GRIVITY
Table of Contents
GRAVITY 2 10W Wireless Charging Power Bank
GRAVITY 2
Manual
Product function
Instruction of wireless charging function
The product could achieve short-range radio transmission by magnetic
induction, applicable to charging for digital products of 5V or 9V.
Communications, furniture, fire
protection, waterproof, and other digital products, this product meet Qi
wireless charging standards. It could be wireless charging with all the Qi
standard receivers.
It can make sure 100% charging precision
Put the phone with wireless charging function on the GRAVITY 2 transmitter correctly, the phone will be wireless charging. Wireless Output voltage: DC5V 1A or DC9V 1.1A
USB input function
GRAVITY 2 can wireless charging by connecting to a safety adapter or Micro USB
wire connect to the computer:
Micro-B Input voltage: DC5V 2.1A or DC9V 2A
USB-C Input voltage: DC5V 2.5A or DC9V 2A
USB-A Output voltage: DC 5V 2.4A or DC9V 2A or 12V 1.5A
USB-c Output voltage: DC 5V 3A or DC9V 2A or 12V 1.5A
Transmitter pad indicator light working description
Power on: After 2 seconds of green and blue indicator light flash alternately.
the indicator light will be turn green for a long time then enter into standby
mode.
Standby: Indicator light will be turn green for a long time charging:
Indicator light will be turn blue for a long time, remove the receiver, the
indicator light will turn green, enter into standby mode.
Automatic protection function
When the transmitter detected its connector’s load current is too large (current exceeds the rated output), the transmitter will shut off with the mobile receiver connection automatically, safety protection automatically. Put the mobile phone in the correct posit again after the move the mobile 5 seconds later. It will re-enter charging status when the connection is successful.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF Exposure: A distance of 15 cm shall be maintained between the antenna and users, and the transmitter may not be co-located with any other transmitter or antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>