EASY HOME Tripod Clothes Dryer Instructions

EASY HOME Tripod Clothes Dryer Instructions

Package contents

Components

1. Upper section
2. Lower section
3. Sliding collar (Lower section)
4. Locking rivet (Lower section)
5. Leg, 3×
6. Arms holder
7. Arm, 3× (Lower section)
8. Sliding collar (Upper section)
9. Arm, 3× (Upper section)
10. Locking rivet (Upper section)
11. Drilled hole
12. Locking button

General information

Reading and storing the user manual

This user manual accompanies this tripod clothes dryer (hereafter referred to as the “product”), and contains important information on setup and handling.

Before using the product, read the user manual carefully. This particularly applies to the safety instructions. Failure to do so may result in personal injury or damage to the product.

Store the user manual for further use. Make sure to include this user manual when passing the product on to third parties.

Proper use

The product is exclusively designed for hanging up clothes for drying. It is only intended for private use and not suitable for commercial purposes.

Only use the product as described in this user manual. Any other use is considered improper and may result in damage to property or persons.

The manufacturer or vendor cannot be held liable for damages or injury incurred through improper or incorrect use.

Safety Instructions

Signal symbol/word definitions
The following symbols and signal words are used in this user manual.

WARNING!
This signal symbol/word designates a hazard with moderate risk, which may result in death or severe injury if not avoided.

NOTICE!
This signal word warns of possible damage to property.
General safety instructions

WARNING!
Risk of injury!
Improper use of the product may cause personal injury.

• Keep the product away from children. Do not leave children unattended near the product.
• The product may only be used with adult supervision and must not be used as a toy.
• Do not exceed the maximum load-bearing capacity of 4.41 lbs (2 kg) per arm. The product is not designed to accommodate weight other than standard loads of laundry.
• Evenly distribute the loading weight on each arm to avoid tipping over.
• Do not use the product if there are any visible damages or if the sliding collars or arms or legs are defective.
• Always ensure that the product is fully and securely open before using it. The sliding collars must be securely locked before use.
• Always remove any clothes on the product before moving.
• Always move the product by using the central pole. Never move, pull, or carry the product by its arms or legs.
• Never lean or climb on the product.
• Never store the product such that there is a risk of it falling over, or falling from an elevated position.
• Make sure that children do not play with the plastic wrapping. They may get caught in it when playing and suffocate.
• Be careful of where you place your fingers and hands while assembling or using the product. You may accidentally pinch your fingers and/or hands.

NOTICE

Risk of damage!
Improper handling of the product may result in damage to the product.

• Install the product on an easily accessible, flat, dry and sufficiently stable surface.
• Never expose the product to high temperatures (heaters etc.) or to the effects of the weather (rain etc.).
• Only use the product indoors. Do not use the product in damp rooms or in the rain or outdoors.
• Never attempt to clean the product by immersing it in water and do not use a steam cleaner to clean it. Otherwise, you could damage the product.
• Stop using the product if its plastic parts exhibit cracks or breaks or are deformed.

First use

Checking the product and package contents

NOTICE!
Risk of damage!
If you are not cautious when opening the packaging with a sharp knife or other pointed object, you may quickly damage the product.

• For this reason, be very careful when opening it.

1. Take the product out of the packaging.
2. Check to make sure that all parts are included (see Fig. A).
3. Check whether the product or individual parts are damaged. If this is the case, do not use the product.

Basic cleaning

• Remove the packaging material and all plastic wrappings.
• Clean all parts of the product before first use as described in the chapter “Cleaning”.

Assembly

WARNING!
Risk of injury!
Improper handling of the product may cause personal injury.

• Make sure all parts are assembled and the sliding collars are locked securely before use.
• Keep children and pets away from the product at all times.

Setting up the lower section

1. Take hold of the shaft of the lower section 2 with one hand.
   Twist the sliding collar 3 counterclockwise to the RELEASE position and push it downwards to spread out the legs 5 (see Fig.   B).
   Make sure the sliding collar is slid over the locking rivets 4 .

2. Twist the sliding collar clockwise to the LOCK position to lock the movement of the legs.

3. Lift up the arms 7 as far as they will go. Then press the arms down at the arm holders 6 to lock the arms in place (see Fig. C).

Setting up the upper section

1. Take hold of the shaft of the upper section 1 with one hand.
   Twist the sliding collar 8 counterclockwise to the RELEASE position and push it upwards to spread out the arms 9 (see Fig. D).
   Make sure the sliding collar is slid over the locking rivets 10 .

2. Twist the sliding collar clockwise to the LOCK position to lock the movement of the arms (see Fig. E).

Combining the upper and lower sections

1. Attach the upper section 1 to the lower section 2 and ensure that the drilled hole 11 is lined up with the locking button 12 (see Fig. F).
2. Depress the locking button and insert the shaft of the upper section into the lower section until the locking button pops out from the drilled hole.

You have sucessfully assembled the product. Make sure the sliding collars 3 / 8 are at the LOCK position before use

Cleaning

NOTICE!
Risk of damage!
Improper handling of the product may result in damage.

• Do not use any aggressive cleaners, brushes with metal or nylon bristles, or sharp or metallic cleaning utensils such as knives, hard scrapers and the like. They could damage the surfaces.

1. Remove all laundry from the product. If necessary, separate the lower and upper sections.
2. Use a damp cloth to wipe off the product.
3. Let all parts dry completely before use or storing.

Storage

All parts must be completely dry before being stored.

• Always store the product in a dry area.
• Protect the product from direct sunlight.
• Store the product so that it is not accessible to children.

Technical data

• Product code: 99360

• Weight: approx. 4.23 lbs (1.92 kg)

• Dimensions (L × W × H)

  • Opened:
    28.34″ × 24.6″ × 64.57″
    (72 × 62.5 × 164 cm)

  • Closed:
    5.83″ × 5.87″ × 62.2″
    (14.8 × 14.9 × 158 cm)

• Maximum weight capacity

  • per arm: approx. 4.41 lbs (2 kg)
  • in total: approx. 26.4 lbs (12 kg)

Disposal

Disposing of the packaging

• Sort the packaging before you dispose of it. Dispose of paperboard and cardboard with the recycled paper service and wrappings with the appropriate collection service.

Disposing of the product

• Should the product no longer be capable of being used at some point in time, dispose of it in accordance with the regulations in force in your city or state.
• Please ensure your recycling information applies to local regulations and the EPA recommendations (www.epa.gov).

References

• U.S. Environmental Protection Agency | US EPA

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>