GE Shower Water Filter Instructions
- June 7, 2024
- GE
Table of Contents
GE Shower Water Filter Instruction
A REPLACEMENT FOR THE FOLLOWING WATER FILTER:
FXSCH
FILTER USE: 6 MONTHS OR 10,000 GALLONS, WHICHEVER COMES FIRST WILL VARY BASED ON WATER CONDITION
FILTER FEATURES
- Economical alternative to expensive substitutes
- Easy installation and operation
- Provides cleaner, fresher water by reducing impurities
- Designed to provide up to 6 months of life or 10,000 gallons
NOTE: This filter should not be use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
OPERATING SPECIFICATIONS
- Minimum operating temperature: 4.4°C/40°F
- Maximum operating temperature: 71°C/160°F
- Min. working pressure: 140 kPa/20 psi
- Max. working pressure: 689 kPa/100 psi
- Rated capacity: 37,900 litres/10,000 gallons
- Flow rate: 9.5 Ipm/2.5 gpm
GENERAL INSTALLATION GUIDELINES
- It is normal for black carbon fines (particles) to appear on the outside of your filter. This happens when the filter is jarred in shipping. It is safe, simply wipe it off.
- Verify that the 0-Ring is present on the filter when tightening to prevent leakage.
INSTALLATION INSTRUCTIONS:
- Turn off the water to the filtration system.
- Remove the filter housing by turning counterclockwise. Be sure to support the shower pipe and the filter housing and base during the filter removal to avoid damage to the system. NOTE: Some water may drip from the system during filter cartridge removal.
- Pull the filter cartridge straight out of the housing and dispose.
- Remove the label at the bottom of the new filter; insert new filter cartridge into the filter base.
- Put the housing back on the base by turning the housing clockwise until it locks into place.
- Slowly turn on the water and check for leaks.
WARNING
To reduce the risk of property damage due to water leakage, this filter MUST
be installed in accordance with the manufacturer’s specifications and
instructions. This filter unit must be replaced every 10,000 gallons or 6
months. Failure to follow instructions and operating specifications will void
your warranty. Further, manufacturer assumes no responsibility or liability
for damages arising out of misuse of the product.
GE® is a registered trademark of General Electric CORP.
CUSTOMER SERVICE
Service: service@water-filter.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>