YAMAHA Speaker Enceinte NS-C700 Owner’s Manual
- June 7, 2024
- Yamaha
Table of Contents
NS-C700
Speaker
OWNER’S MANUAL
Thank you for selecting this YAMAHA product.
PRECAUTIONS
Read this before using the speaker.
-
To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference.
-
Install the speaker in a cool, dry, clean place – away from windows, heat sources, sources of excessive vibration, dust, moisture, and cold. Avoid sources of electrical noise (transformers, motors). To prevent fire or electrical shock, do not expose this unit to rain or water.
-
To prevent the enclosure from warping or discoloring, do not place the speaker where it will be exposed to direct sunlight or excessive humidity.
-
Do not place the following objects on the speaker:
Glass, china, small metallic, etc.
If glass, etc., falls as a result of vibration and breaks, it may cause bodily injury.
A burning candle, etc. If the candle falls as a result of vibrations, it may cause fire and bodily injury.
A vessel with water in it If the vessel falls as a result of vibrations and water spills, it may cause damage to the speaker, and/or you may get an electric shock. -
Do not place the speaker where foreign material such as dripping water is present. It might cause fire, damage to this unit, and/or personal injury.
-
Do not place the speaker where it is liable to be knocked over or struck by falling objects. Stable placement will also ensure better sound performance.
-
Placing the speaker on the same shelf or rack as the turntable can result in acoustical feedback.
-
Never put a hand or a foreign object into the port located on the rear of the speaker, as this might cause personal injury and/or damage to the speaker.
-
When moving the speaker, do not hold the port, as it might cause personal injury and/or damage to the speaker.
-
Any time you notice distortion, reduce the volume control on your amplifier. Never allow your amplifier to be driven into “clipping.” Otherwise, the speaker may be damaged.
-
When using an amplifier with a rated output power higher than the nominal input power of the speaker, care should be taken never to exceed the speaker’s maximum input.
-
Do not attempt to clean the speaker with chemical solvents, as this might damage the finish. Use a clean, dry cloth.
-
Do not attempt to modify or repair the speaker. Contact qualified YAMAHA service personnel when any service is needed. The cabinet should never be opened for any reason.
-
Secure placement and installation are the owner’s responsibility. YAMAHA shall not be liable for any accident caused by improper placement or installation of speakers.
Information for Users on Collection and Disposal of Old Equipment
This symbol on the products, packaging, and/ or accompanying documents means
that used electrical and electronic products should not be mixed with general
household waste.
For proper treatment, recovery, and recycling of old products, please take
them to applicable collection points, in accordance with your national
legislation and the Directives 2002/ 96/EC.
By disposing of these products correctly, you will help to save valuable
resources and prevent any potential negative effects on human health and the
environment which could otherwise arise from inappropriate waste handling.
For more information about the collection and recycling of old products,
please contact your local municipality, your waste disposal service or the
point of sale where you purchased the items.
[For business users in the European Union] If you wish to discard electrical
and electronic equipment, please contact your dealer or supplier for further
information.
[Information on Disposal in other Countries outside the European Union] This
symbol is only valid in the European Union. If you wish to discard these
items, please contact your local authorities or dealer and ask for the correct
method of disposal.
SUPPLIED ACCESSORIES
PLACING THE SPEAKERS
Place the speaker on a TV rack or other stable surface. To prevent the speaker from falling down, attach the fasteners provided in each corner of the speaker’s underside.
Notes
- Do not touch the adhesive surface after peeling off the seal as this will weaken its adhesive strength.
- Thoroughly wipe clean the surface where the fasteners are to be attached. Note that adhesive strength is weakened if the surface is dirty, oily or wet and that this may cause the center speaker to drop.
- Placing this unit too close to a TV set might impair picture color or create a buzzing noise. Should happen, move the speaker away (more than 20 cm (7-7/8”)) from the TV set.
- To avoid accidents resulting from tripping over loose speaker cables, fix them to the floor.
CONNECTIONS TO YOUR AMPLIFIER
Before making connections, make sure that the amplifier is switched off.
- Connect the screw-type input terminals at the rear of the speakers to the speaker output terminals of the amplifier (or receiver) with the speaker cable.
- Connect the (+) terminals on the amplifier (or receiver) to the (+) terminal of each speaker, making sure to confirm the color-coded wire of the cable at each end. Use the other wire of the cable to connect the (–) terminals of the components.
- Connect the speaker to the center terminals of your amplifier, making sure not to reverse the polarity (+, –). If the speaker is connected with reversed polarity, the sound will be unnatural and lack bass.
How to connect
-
Loosen the knob.
-
Remove 10 mm (3/8”) of insulation from each end of the cables, and twist the exposed conductors together neatly and tightly, as shown below.
-
Insert the bare wire.
-
Tighten the knob and secure the cables.
Test the firmness of the connection by pulling lightly on the cables at the terminal.
Notes
- Do not let the bare speaker wires touch each other as this could damage the speaker or the amplifier, or both.
- Do not insert the insulation into the hole. The sound may not be reproduced.
When using a banana plug
Note
Do not take off this cover unless using a banana plug.
- Tighten the terminal knob.
- Remove the cover by pulling it toward you.
- Simply insert the banana plug into the terminal.
Note
Use a suitable instrument to remove the cover. Removing it with your bare
hands may hurt your fingertips.
ATTACHING THE FRONT COVER
The speaker and the front cover are packed separately. To attach the front cover, line up the projections (magnets) on the reverse side of the front cover with their corresponding screw heads on the speaker.
Notes
- When removing the cover, be careful that you don’t touch the drive units, and don’t exert excessive force with any tools.
- There are magnets on the reverse side of the front cover. Do not place a front cover close to objects that might be affected by magnets, such as TV, clock, magnetic card, diskette, etc, after removing it.
SPECIFICATIONS
Type| 2-way acoustic suspension speaker system
Non-Magnetic shielding type
---|---
Driver| 3 cm (5”) cone woofer × 2
Advanced PMD
3 cm (1”) aluminum dome tweeter
DC diaphragm
Impedance| 6 Ω
Frequency Response| 60 Hz to 50 kHz (-10 dB)
100 kHz (-30 dB)
Nominal Input Power| 40 W
Maximum Input Power| 160 W
Sensitivity| 89 dB/2.83 V/m
Crossover Frequency| 5 kHz
Dimensions (W × H × D)| 500 × 170 × 170 mm
(19-11/16” × 6-11/16” × 6-11/16”)
Weight| 7 kg (15 lbs. 7 oz.)
- Specifications are subject to change without notice due to product improvements.
- Care should be taken not to exceed the input power values noted above.
- A speaker cable is not included with this model.
Taking care of the speaker
When you wipe this unit, do not use chemical solvents (e.g., alcohol or
thinners, etc.): this might damage the finish. Use a clean, dry cloth. For
difficult soils, dampen a soft cloth in detergent diluted with water, wring it
out, and then wipe with the cloth.
Limited Guarantee for European Economic Area (EEA) and Switzerland
Thank you for having chosen a Yamaha product. In the unlikely event that your
Yamaha product needs guarantee service, please contact the dealer from whom it
was purchased. If you experience any difficulty, please contact Yamaha
representative office in your country. You can find full details on our
website (http://www.yamaha-hifi.com/ or http://www.yamaha-uk.com/ for U.K.
residents).
The product is guaranteed to be free from defects in workmanship or materials
for a period of two years from the date of the original purchase. Yamaha
undertakes, subject to the conditions listed below, to have the faulty product
or any part(s) repaired, or replaced at Yamaha’s discretion, without any
charge for parts or labor. Yamaha reserves the right to replace a product with
that of a similar kind and/or value and condition, where a model has been
discontinued or is considered uneconomic to repair.
Conditions
-
The original invoice or sales receipt (showing date of purchase, product code, and dealer’s name) MUST accompany the defective product, along with a statement detailing the fault. In the absence of this clear proof of purchase, Yamaha reserves the right to refuse to provide free-of-charge service and the product may be returned at the customer’s expense.
-
The product MUST have been purchased from an AUTHORISED Yamaha dealer within the European Economic Area (EEA) or Switzerland.
-
The product must not have been the subject of any modifications or alterations unless authorized in writing by Yamaha.
-
The following are excluded from this guarantee:
a. Periodic maintenance and repair or replacement of parts due to normal wear and tear.
b. Damage resulting from:
(1) Repairs performed by the customer himself or by an unauthorized third party.
(2) Inadequate packaging or mishandling, when the product is in transit from the customer. Please note that it is the customer’s responsibility to ensure the product is adequately packaged when returning the product for repair.
(3) Misuse, including but not limited to (a) failure to use the product for its normal purpose or in accordance with Yamaha’s instructions on the proper use, maintenance, and storage, and (b) installation or use of the product in a manner inconsistent with the technical or safety standards in force in the country where it is used.
(4) Accidents, lightning, water, fire, improper ventilation, battery leakage, or any cause beyond Yamaha’s control.
(5) Defects of the system into which this product is incorporated and/or incompatibility with third-party products.
(6) Use of a product imported into the EEA and/or Switzerland, not by Yamaha, where that product does not conform to the technical or safety standards of the country of use and/or to the standard specification of a product sold by Yamaha in the EEA and/or Switzerland.
(7) Non-AV (Audio Visual) related products.
(Products subject to “Yamaha AV Guarantee Statement” are defined in our website at http://www.yamaha-hifi.com/ or
http://www.yamaha-uk.com/ for U.K. residents.) -
Where the guarantee differs between the country of purchase and the country of use of the product, the guarantee of the country of use shall apply.
-
Yamaha may not be held responsible for any losses or damages, whether direct, consequential, or otherwise, save for the repair or replacement of the product.
-
Please backup any custom settings or data, as Yamaha may not be held responsible for any alteration or loss to such settings or data.
-
This guarantee does not affect the consumer’s statutory rights under applicable national laws in force or the consumer’s rights against the dealer arising from their sales/purchase contract.
Printed in Indonesia WP33690-1
©2008 Yamaha Corporation All rights reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>