YAMAHA NS-AW294 Outdoor Speaker Owner’s Manual

NS-AW294/NS-AW194
OUTDOOR SPEAKER
ENCEINTE D’EXTERIEUR

NS-AW294 Outdoor Speaker

CONSUMER PRECAUTIONS

Read these precautions carefully before setting up your NS-AW294 / NS-AW194 speakers.

• When installing these speakers outdoors, try to minimize their exposure to rain and snow by mounting the speaker in corners or under eaves.
• Since these speakers are to be wall / ceiling mounted, it is essential that they are firmly secured. Be sure to consult a reliable source about the best type of fastener for your particular wall / ceiling’s construction.
• Do not attach them to thin plywood or soft wall / ceiling surface materials as the screws may tear free, causing the speakers to fall and be damaged, or result in personal injury.
• Do not fasten the speakers to wall / ceiling with nails, adhesives, or other unsafe hardware. Long-term use and vibrations may cause them to pull free.
• Do not place the speakers where they are liable to be knocked over or struck by falling objects. Stable placement will also ensure better sound performance.
• When ganging the angle of the speakers, be sure to adjust the angle after loosening the knob on the both sides. The speakers may be damaged by excessive power.
• Lower the power amplifier / receiver volume control before changing input sources. Always turn the amplifier / receiver unit off when installing or removing input cables.
• Anytime you note distortion, reduce the volume control on your power amplifier / receiver to a lower setting. Never allow your power amplifier to be driven into “clipping”.
• Do not attempt to modify or fix the speakers. Contact qualified Yamaha service personnel when any service is needed. The cabinet should never be opened for any reasons.
• Do not attempt to clean the speakers with chemical solvents as this might damage the finish. To clean wipe with a dry. soft cloth.
• Secure placement or installation is the owners responsibility. Yamaha shall not be liable for any accident caused by improper placement or installation of speakers.

UNPACKING

After unpacking, please inspect contents to confirm all the following items are contained.
A. Speaker x 2
B. Bracket x 2
C. Knob x 4

BEFORE INSTALLATION

Please read carefully before installation.

• Make sure that there is sufficient space without obstructions on a wall / ceiling for installation. Be aware of the product dimensions and weight (See SPECIFICATIONS below).
• Before installing the speakers, run the speaker cables to the installation location.

MOUNTING THE SPEAKERS

To wall / ceiling mount the speakers, use the included bracket.

1. Using the bracket as a template mark the locations (four points) of the key hole slots on the mounting area.

2. Using appropriate hardware (not included) securely fasten the bracket to the wall / ceiling.

3. Position the speaker in the bracket and secure the speaker by using the two knobs included.
   Notes:
   • When using the brackets to mount the speakers on a wall / ceiling, please use safety wire (not included) between the bracket and the wall I ceiling to prevent the speaker from falling.
   • When adjusting the angle with the bracket fixed to the speaker, loosen the knobs on both sides before changing the direction of the speaker. (Angle adjustment can be performed after the knobs, fastened tightly, are loosened by rotating them 2 to 2-1/2 times.) When excessive force is applied while the knob is tightly shut, the fixed portion may collapse and angle adjustment will be disabled. After adjusting the angle, tighten the knob so that the speaker will be steadfast.

4. Rotate the YAMAHA emblem according to the position of the speaker.

If speaker cable (not included) is being fed from a hole in the wall / ceiling behind the bracket, pull this speaker cable through the hole in the bracket before mounting the bracket [figure 3 – a].

CONNECTING YOUR AMPLIFIER / RECEIVER

Before making connections, make sure that the amplifier / receiver is switched off.
CONNECTIONS

• Connect the input terminals at the rear of the speakers to the speaker output terminals of the amplifier I receiver with the speaker cables (not included).
• Connect each speaker making sure not to reverse the polarity “+” (red), “—” (black). If the speaker is connected with reversed polarity, the sound will be unnatural and lack bass.

HOW TO CONNECT

1. Remove approximately 10 mm (318″) of insulation from the end of each speaker cable and twist the exposed wires of the cable together to prevent short circuits.
2. Press and hold the terminal tab.
3. Insert the bare wire.
4. Release the tab so that it closes security on the bare wire, not the insulation.
5. Test the security of the connection by pulling gently on the cable.

Notes:

• Do not let the bare speaker wires touch each other as this could damage the speaker or amplifier / receiver, or both.
• Make sure the terminal is gripping the bare wire, not the insulation.

SPECIFICATIONS (For single speaker)

| NS-AW294 I| NS-AW194
---|---|---
Type| 2-Way Bass Reflex
Driver| Tweeter| 2.5 cm (1″) Balanced dome type
Woofer| 16 cm (6-1/2″) cone type| 10 cm (4″) cone type
Frequency response| 80 Hz to 20 kHz (-10 dB)| 100 Hz to 20 kHz (-10 dB)
Impedance| 8 ohms
Nominal input| 50 W| 30 W
Maximum input| 100 W| 80 W
Sensitivity| 87 dB/ 2.83 V, 1 m| 85 dB/ 2.83 V, 1 m
Dimensions (W x H x D) (excluding bracket and knobs)| 190 x 308 x 217 mm
(7-1/2″ x 12-1/8″ x 8-1/2″)| 152 x 243 x 171 mm
(6″ x 9-5/8″ x 6-3/4″)
Weight (including bracket and knobs)| 2.3 kg (5.1 lbs.)| 1.6 kg (3.5 lbs.)
Movable angle| 13.5 degree pitch| 13.5 degree pitch

• Specifications subject to change without notice due to product improvements.

NS-AW Series

Surface Mount Speakers High performance outdoor speakers with outstanding sound quality and weatherproofing.
The simple design allows them to be installed in many types of locations.
High Sound Quality

• Yamaha’s advanced speaker design combines superior sound quality with excellent weatherproofing

• Two-way bass reflex design
  – Powerful woofer delivers accurate mid/low frequency response
  – Balanced dome tweeter ensures clear high frequency response

• Excellent audio performance, weatherproof cabinets that are drip, water and UV resistant

Convenient Design

• Simple design looks natural on a home exterior, on a patio or inside a room
• Two sizes and two color variations allows you to choose the best match in various installations
• Flexible installation options with supplied mounting brackets
• Powder-coated grilles provide outstanding weatherproof properties
• Push type speaker terminals for easy installation

Convenient Design and Features
Simple, Elegant Design
These speakers have a clean, simple design that will look attractive in any location on the exterior of your house, and even present a tasteful appearance when used in an interior installation.
Two sizes, Two Colors
Available in two types and in white or black, you can choose the model that best matches your desired exterior or interior installation location.
Wide Range of Installation Possibilities
The supplied brackets allow you to adjust the speakers to match the installation location. They can be installed vertically or horizontally, and can be moved through a range of 81° to the right or left and up or down directions.

N S-AW294

GENERAL SPECIFICATIONS

190 x 308 x 217 mm
Weight| 4.4 lbs.; 2 kg/unit
Included accessories| U-bracket, Retaining kob
Packaging| Packaged in pair

• Product designs and specifications are subject to change without notice.

DIMENSIONS

N S-AW194
GENERAL SPECIFICATIONS

152 x 243 x 171 mm
Weight| 2.9 lbs ; 1.3 kg/unit
Included accessories| U-bracket, Retaining kob
Packaging| Packaged in pair

• Product designs and specifications are subject to change without notice.

DIMENSIONS

Documents / Resources

| YAMAHA NS-AW294 Outdoor Speaker [pdf] Owner's Manual
NS-AW294, NS-AW194, NS-AW294 Outdoor Speaker, Outdoor Speaker, Speaker
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>