CA-404B Circulator Fan with Ionizer Clean Air Optima User Manual
- June 3, 2024
- Clean Air Optima
Table of Contents
- CA-404B Circulator Fan with Ionizer Clean Air Optima
- Description of the device
- Safety warnings
- Features
- Installation and Operating instructions
- Remote control
- Cleaning and maintenance
- Troubleshooting
- Specifications
- Service
- Other Conditions
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
CA-404B Circulator Fan with Ionizer Clean Air Optima
Thank you for purchasing the Clean Air Optima® Circulator-fan with ionizer
CA-404B.
We wish you many years to have a pleasant room climate and healthy indoor air
with this efficient and effective Clean Air Optima® product. These
instructions describe the safety precautions to be observed during operation.
They are meant to prevent injuries and to avoid damaging the device.
Description of the device
The device consists of the following main components:
- Removable protection grid
- Protection grid cover
- Protection grid decoration net
- Protection grid rear
- Foldable stand
- Foldable stand cover
- Steppless speed swicht knob
- Digital display
- Top of the housing
- Housing
- Foot
Safety warnings
This device may only be used in accordance with these safety instructions. Take the following steps to minimize the risk of personal injury caused by for example electric shocks or fire.
- Only for indoor use. Do not use or store outdoors.
- Use proper voltage: AC 220V – 240V, 50Hz
- Make sure that the air outlets are always free, clean up dust, hair and other obstruction for the airflow and at the air outlets.
- Keep your hair, clothes, jewels or fingers away from the air outlets.
- T he device is not intended to be used by children or persons with reduced physical-, sensory- or mental capabilities, unless they are supervised by a person responsible for their safety.
- Children should be kept away unless continuously supervised.
- To safely use the device, put it in a steady, horizontal position. Do not move while using.
- Do not use the device when there is visible damage on the electrical cord or on the device itself. Do not repair the device yourself in case of damage. Never pull the device by its cord. If the power ord is damaged, then it must be replaced by an authorized service person to prevent electric shock or fire.
- Repairs may only be performed by authorized service personal. Do not try to repair the device yourself to prevent electric shock or fire.
- Always remove the plug from the socket when the device is not being used or when you clean internal or external parts of it.
- Do not use the device in rooms where inflammable liquids or gases are stored, close to heat sources or in particularly humid rooms like the bathroom, shower or swimming pool.
- To prevent malfunctions, never insert strange objects into the device.
- Never disassemble or replace the device’s inner parts.
- Do not place the device in direct sunlight, to avoid the device’s discolors.
- Never immerse the unit in water or other liquids.
- Do not touch the power cord with wet hands.
- Clean the device before storage. Store the machine in a cool and dry place outside the reach of the children.
- Do not ingest the battery, the battery is a Chemical Burn Hazard.
- This device contains a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to serious complaints or disease.
- Keep new and used batteries away from children.
- If the battery compartment does not close securely, stop using the device and keep it away from children.
- f you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.
- The batteries contain materials, which are hazardous to the environment, they must be removed from the device before it is scrapped and they are disposed of safely.
- Use, maintain and clean the device as described in this manual.
Features
- Stepless Speed Switch Knob with 24-speed levels.
- Timer function 1 – 12 hours.
- Remote control function.
- Negative ion >3.000.000 /cm³.
- Oscillation function, automatic swing in the horizontal direction up to 80°; manual swing in a vertical direction up to 180°.
- Sleep Air Flow mode.
- The display led lights will automatically turn off after 1 minute of use and or inactivity of the display.
- Foldable for easy storage.
- Uninterruptible power memory function.
- Dynamic Natural Air Flow
Installation and Operating instructions
The package contains: circulator-fan, remote control and instruction manual.
Assembling the device
- Take out the device from the package.
- Carefully put the device on a stable surface.
- The device needs to be positioned at least 20 cm from a wall.
Operating Functions
Plug in the device: you will hear an acoustic sound “Bi, Bi”.
ON/OFF button
Press the button, the circulator-fan starts working. Press it again, the
device turns off.
Steppes Speed Switch Knob
Turn the switch knob to the right to increase the wind speed levels. The
digital display will show the corresponding wind speed level. If you continue
to rotate to the right you will reach an maximum wind speed level of 24 and
you will hear the acoustic sound “Bi”. Rotate the switch knob to the left to
decrease the wind speed level. If you continue to rotate to the left you will
reach an minimum wind speed level of 1 and you will hear the acoustic sound
“Bi”.
Dynamic Natural Air Flow
Press the button, to turn on the Dynamic Natural Air Flow mode, the digital
display will show level 8. Use the switch knob and rotate to the right to
switch to level 16 and 24 or switch back to 16 and 8 by rotating the switch
knob to the left.
24 levels are divided into three groups
- 1 – 8 low level = level 8 on display
- 9 – 16 middle level = level 16 on display
- 17 – 24 high level = level 24 on display
The wind speed levels in 8, 16 and 24 are preprogrammed for the Dynamic Natural Air Flow, the circulator-fan will operate according to the diagram below:
- Press again to turn off the Dynamic Natural Air Flow mode.
Sleep Air Flow
- Press the button, to turn on the Sleep Air Flow mode, the digital display will show level 6. The wind speed levels can be adjusted from level 6 to level 1 with the switch knob by rotating to the left. When operating for example in Sleep Air Flow mode level 6, the wind speed will be reduced by one level (6 to 5, 5 to 4, 4 to 3, 3 to 2, 2 to 1, 1 = continuous) every 30 minutes. Press again to turn off the Sleep Air Flow mode.
Timer
Pressing the button, sets the timer. The timer function determines how many
hours the circulator-fan will operate. You can set the timer simply by turning
the switch knob to the right or left and the digital display will show the
selected time you would like to run the device. The timer can be set from 1
hour to 12 hours. As time passes, the time value decreases until it goes to
00:00 hours and the device shuts off.
- Press again to turn off the Timer function.
80° Oscillation
- Pressing the button, sets the 80° automatic oscillation. The circulator-fan will oscillate to the right angle of 45° and to the left angle of 45°.
- Press again to turn off the 80° Oscillation function.
Negative Ion
- Pressing the – button, will activate the negative ion generator with a total capacity of > 3.000.000 negative ions / cm³ that are spread from the fan air flow through out the entire room and thereby neutralize pollutants and smells. Negative ions attach onto dust particles, microorganisms and other unwanted particles in the air and connect them to each other. This way, the particles become heavier than air and fall onto the ground so that you can no longer breathe them in.
- Negative ions are most found in the forest, mountains and by the sea. Negative ions ensures fresh and healthy air.
- Press again to turn off the Negative Ion function.
Remote control
The buttons on your remote control:
- ON/OFF
- Timer
- 80° oscillation
- Program setting
- Wind speed level 1-24
- Negative ion
Replacing batteries in the remote control
- Open the battery cover at the back side of the remote control to place the battery. (see picture 1).
- To place the battery: there is a “security tab” at the bottom of the remote control that you first have to slide to the right and then pull out the battery holder. (see picture 2). Insert the battery with the correct polarity. (see picture 3). 3. Push the battery cover back into the remote control.
Cleaning and maintenance
- Before cleaning the device, unplug the power cord.
- Clean the housing with a soft moisture cloth. Do not use chemical solvent (such as benzene, alcohol, gasoline). The surface may be damaged or even the whole case may be deformed. The circulator-fan has an detachable front for easy cleaning (see picture 1). Use a Philips-head screwdriver and remove the screw from the rear protection grid (see picture 2). Then turn the detachable front on the front side a quarter to the left and take out the grid. You can now remove dirt and dust from the blades with a soft moisture cloth (see picture 3).
- Do not sprinkle water on the device.
- If the circulator-fan is not used for a longer period of time, we advise to clean the device carefully and let it dry. The device has to be stored in a cool and dry place.
Troubleshooting
The following is a troubling shooting guide to help you solve any issues that you may have using the Clean Air Optima® Circulator-fan CA-404B
WARNING!
If the above-recommended solutions do not work, please contact Clean Air
Optima® technical support at the telephone number for your region. Do not
attempt to disassemble, reassemble, or repair the device as this may void the
warranty.
Specifications
- Model CA-404B
- Rated voltage 220V – 240V, 50Hz
- Rated power 25W
- Noise level < 10dB(A) (Speed 1) ≤ 55dB(A) (Speed 24)
- Airflow 660m³/H
- Turning circle Horizontal 80° Automatic oscillation
- Vertical 180° Manual rotation
- Dimensions 240 x 240 x 345 mm
- Weight 2,1 kg
- Colour Black
- Carried standard IEC/EN 60335-1 IEC/EN 60335-2-80 IEC/EN 62233:2008
- Complies with EU
- regulations CE / WEEE / RoHS
Ask your retailer or your municipality for updated information regarding the disposal of the packaging and of the device.
Service
Warranty Certificate for the Clean Air Optima® Circulator-fan with ionizer CA-404B.
- Date of purchase: …………………………………………………………………………………………
- Customers name: …………………………………………………………………………………………
- Address: ……………………………………………………………………………………………………………
- Telephone: ……………………………………………………………………………………………………….
- Email: ………………………………………………………………………………………………………..………..
- Seller’s name: …………………………………………………………………………………………………
- Address: ………………………………………………………………………………………………..………….
- Please fill in completely this Warranty Certificate. Send it with the invoice and the unit, postage pre-paid and using the original packing box, to your distributor. Make sure to include the appropriate return postage for the package.
- Please enclose a short description of the damage, fault or malfunction, and the circumstances under which these problems arose.
The Clean Air Optima® Circulator-fan with ionizer CA-404B is subjected to strict testing procedures before leaving the factory. If within 2 years from the date of purchase the product does not perform according to the specifications, because of factory defects, the purchaser is entitled to free repairs or replacement of parts upon presentation of this warranty (provided that the malfunction or damage to the device and/or parts occurred under normal operating conditions). What is covered: All parts defective in material and workmanship. For how long: two years from purchase date. What we will do: Repair or replace any defective parts.
Other Conditions
The provisions of this warranty are in lieu of any other written warranty whether express or implied, written or oral, including any warranty of merchantability or fitness for a particular purpose. The manufacturer’s maximum liability shall not exceed the actual purchase price paid by you for the product. In no event shall the manufacturer be liable for special, incidental, consequential, or indirect damages. This warranty does not cover a defect that has resulted from improper or unreasonable use or maintenance, faulty assembly, accident, natural catastrophes, improper packing, or unauthorized tampering, alteration, or modification as determined solely by us. This warranty is void if the label bearing the serial number has been removed or defaced.
Thank you for reading!
- Share your feedback about the Clean Air Optima® Circulator-fan with ionizer CA-404B on: www.cleanairoptima.com
- For frequently asked questions about the CA-404B go to: www.cleanairoptima.com and search for the CA-404B.
- Download PDF instruction manual on: www.cleanairoptima.com/info/manuals
- Watch all Clean Air Optima® Product animation video’s on: www.youtube.com
Clean Air Optima International B.V. | David Ricardostraat 9-7 / 9-9 | 7559 SH Hengelo (ov) The Netherlands | Phone: +31 (0) 74 – 2670145
Clean Air Optima Germany GmbH | Enschedestraße 14 | 48529 Nordhorn | Germany Phone: +49 (0) 5921 879-121
- E-mail: info@cleanairoptima.com
- Internet: www.cleanairoptima.com
- More info: www.cleanairoptima.com
Trademarks owned by: Clean Air Optima Germany GmbH, © 2021 Clean Air Optima Enschedestraße 14, 48529 Nordhorn, Germany
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>