NanoRS RS166 Gaming Mount for Two RGB LED Monitors Instruction Manual
- June 3, 2024
- nanoRS
Table of Contents
NanoRS RS166 Gaming Mount for Two RGB LED Monitors
IN THE BOX
TOOLS REQUIRED
REMOTE CONTROL
Note: Remove the plastic battery insert prior to using the remote.
- On/Off
- Effect Speed +/-
- Effect Mode +/-
- Short Press 1 Time: automatic effect show Short Press 5 Times :7 single-color light show
- Brightness +/-
- Lock/Unlock The Remote Long press 5 seconds remote control one to one match, again press 5 seconds to cancel the match.
- Set At automatic playback mode, press the “Set” button once, then the “Lock” button to capture the current effect loop play
- Steady Single Colors
CONNECTION
The remote control is provided for lighting control. Stick the remote control
to the magnet pad on the monitor arm when not in use.
Note: Finish step before connecting the USB to plastic prior to using
your appliances.
Gaming mount for two RGB LED monitors, 17-32″
Read the entire instruction manual before you start installation and assembly. If you have any questions regarding any of the instructions or warnings, please contact your local distributor Tor assistance,
CAUTION
- Use with products heavier than the rated weight indicated may result in instability causing possible injury.
- Units must be attached as Speclned in assembly instructions. improper installation may result in damage or serious personal injury.
- Safety gear and proper tools must be used. This product should only be installed by professionals.
- Make sure that the supporting Surtace will safely support the combined weight of the equipment and all attached hardware and components.
- Use the mounting screws provided and DO NOT OVvER TIGHTEN mounting screws
- This product is intended for indoor use only, Use this product outdoors today.
IMPORTANT: Ensure that you have received all parts according to the component checklist prior to installation. If any parts are missing or faulty, telephone your local distributor for a replacement.
MAINTENANCE
Check that the bracket is secure and safe to use at regular intervals (at least every three months).
INSTALLATION INSTRUCTION
To properly balance the arm with monitors mounted, adjust the spring tension using the supplied Allen Key as followS:
CAUTION: To avoid damage to monitors or mount, always keep the arm in a horizontal position while making adjustments. Again, ask for assistance if required.
- lf the arm drops, turn the adjustment screw clockwise until it stays in a horizontal position.
- If the arm rises, turn the adjustment screw counter-clockwise until it stays in a horizontal position.
- CAUTION: DO NOT over tighten the screws.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>