COR RI PCK 22257 Key Light MK.2 User Guide
- June 16, 2024
- COR RI PCK
Table of Contents
Quick Start Guide
Set up your Key Light
Screw Key Light directly onto the pole via the integrated socket and screw. Extend the pole to your preferred height.
A non-slip rubber washer is included for mounting a camera, camcorder, etc. It is recommended that you remove it when mounting Key Light.
-
Tighten
-
Loosen
-
Do not overtighten.
-
Push the button to position the ratchet after tightening.
-
Padded and expandable up to 6 cm / 2.35 in
-
Connect the power supply and plug it into a power outlet.
-
I = ON
-
0 = OFF
-
II = RESET
-
Minimum 55 cm / 22 in
Maximum 125 cm / 49 in
(90 cm / 35 in recommended)
It is normal for the pole to shake when fully extended. -
Maximum load 2 kg / 4.5 lbs
Installation (Software)
1
Download and install the Control Center app.
2
Switch on your Key Light. It will take approximately 15 seconds to boot up.
3
Launch Control Center and pair Key Light by clicking the + icon.
4
Use Control Center to switch Key Light on/off, adjust brightness, and fine- tune color temperature.
If your PC is not equipped with Wi-Fi, use the Elgato Control Center app from the App Store or Google Play to add and control Key Light from an iOS or Android device. Wi-Fi connection is only needed for initial pairing. Once Key Light is added to your network, you can control it via any Mac or Windows PC within your network.
Reset
RESET will restore your Key Light factory settings and forget all Wi-Fi credentials.
Power off Key Light. Push and hold the RESET Button (II) for at least 10 seconds until the light flashes 3x. Wait a moment before switching on Key Light again.
Warning
- Key Light may become hot during prolonged use. Always handle with care.
- Do not cover this product, especially the ventilation holes.
- Do not place on or near a carpet, curtains, or any other flammable materials.
- Be especially cautious when setting up near children.
- Do not attach items to Key Light or its pole.
- Do not leave the product exposed to direct sunlight.
- Do not set up in areas susceptible to strong air currents. Drafts and breezes can cause movement that may result in damage to the product.
- Keep the light free from dirt and dust. If Key Light becomes dirty, wipe it lightly with a soft cloth moistened with a little water and mild, neutral detergent. Benzene, thinner, and other volatile agents can cause permanent damage and should never be used for cleaning.
- Always mount the pole to a level, stable surface. Uneven or unstable surfaces may cause tipping and result in damage or personal injury.
- Do not use the pole for applications other than those specified in this guide or the packaging.
Frequency range: 2412 – 2472 MHz (2462 MHz for FCC, ISED), Max RF e.i.r.p power < 20 dBm, Temperature range: 0 °C – 45 °C. Hereby, Corsair Memory Inc. declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EC. The declaration of conformity for Elgato products is available at www.elgato.com/doc
| FCC| IC| CE
---|---|---|---
2.4 GHz| 2412 – 2462 MHz| 2412-2462 MHz| 2412-2472 MHz
5 GHz (Band 1 & 2)| 5180 – 5320 MHz| 5180 – 5320 MHz| 5180 – 5320 MHz
5 GHz (Band 3)| 5500 – 5700 MHz| 5500 – 5800 MHz
5660 – 5700 MHz| 5500 – 5700 MHz
5 GHz (Band 4)| 5745 – 5825 MHz| 5745 – 5825 MHz | x
CE Wi-Fi 2.4 GHz Max RF e.i.r.p power < 20dBm, Wi-Fi 5 GHz Max RF e.i.r.p. power < 23dBm, Temperature range: 0 °C – 45 °C
This equipment complies with FCC RF, IC1155-102 and CE radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. For indoor use only.
Hereby, Corsair Memory Inc. declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EC. The declaration of conformity for Elgato products is available at www.elgato.com/doc
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one of the
following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and a human body.
For questions about Elgato product compliance with FCC regulations, please contact: Compliance Officer, Corsair Memory Inc., 115 North McCarthy Blvd, Milpitas, CA 95035, USA
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Elgato, a division of:
CORSAIR MEMORY, Inc. 115 North McCarthy Blvd, Milpitas, CA 95035, USA
CORSAIR MEMORY, BV. Wormerweg 8, 1311 XB, Almere, Netherlands
CORSAIR COMPONENTS, Ltd. 1020 Eskdale Road, Winnersh Triangle, Wokingham, RG41
5TS, UK
Copyright 2018 – 2022 Corsair Memory Inc. All rights reserved. Elgato and the
Elgato logo are trademarks of Corsair Memory Inc., registered in the U.S. and
other countries.
Part: 51GAK9920
Documents / Resources
| COR
RI PCK 22257 Key Light
MK.2
[pdf] User Guide
22257 Key Light MK.2, 22257, Key Light MK.2, Light MK.2, MK.2
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>