ZYXEL Desktop Gigabit Ethernet Switch Series User Guide

: June 7, 2024
: ZYXEL

Table of Contents

Hardware Installation
Troubleshooting
Support Information
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Desktop Switch Series
Quick Start Guide

Hardware Installation

ZYXEL Desktop Gigabit Ethernet Switch Series - fig11

Connect to an appropriate power source. Connect to a modem or router that has internet access.
Option A
Managed with ZON Utility for DHCP Environment
(For Wob managed Switch Only)

ZYXEL Desktop Gigabit Ethernet Switch Series - fig2 |
---|---

Connect the Switch and your computer to the same network that has a DHCP server.
Use the ZON utility to discover the Switch. Select the Switch and click the Web GUI icon to access its web configurator.

Option B
Managed with Switch Default Static IP (For Web Managed Switch Only)

ZYXEL Desktop Gigabit Ethernet Switch Series - fig4 |
---|---

Connect your computer to the Switch using an Ethernet cable. Your computer must have an IP address in the same subnet as the Switch.
Launch your web browser and go to http://1921681.3. Enter 1234 as the password. Click SIGN IN.

Troubleshooting

I cannot see or access the Login screen in the Web Configurator.

Make sure you are using the correct IP address. (The default IP address is 192.169.13)
make sure your computer is in some subnet as the Switch. If you haven’t changed the default IP address, your computer IP address should be in the 1921681.4 – 1921681.254 range.
Make sure you have entered the password correctly. If you have changed the password and have forgotten It. you’ll have to reset the Switch to its factory default. (The default Password is 1234.)
Aloe is detected.
A loop may happen in the following example situations:
1. The Switch is connected to the nether device in o loop state
2. The Switch is connected to another device with two cables.
Loop Prevention Is enabled by default If o loop happens, the Switch will block the port in a loop state. If o loop happens on two ports, the Switch will block the higher-numbered port. For example, if a loop happens on ports 4 and 5, the Switch will block Port 6 and its LED will be off. To restore a port in a loop state. disconnect it. check the network connections, and reconnect them.
You can log into the Web Configurator. Go to System in the Web Configurator to check your port status

Your Networking Ally

http://www.zyxel.com/support/warranty_information.shtml

Warranty Card

Thank you for purchasing a Zyxel product Zyxel has a reputation for delivering high-quality, high-performance products and services to our customers.
We recommend that you now visit the Zyxel website and register your product online.
This will mean you can receive the latest firmware, drivers, and product- related information.
If you still have further questions or inquiries related to the product, please contact our subsidiaries worldwide.
Please note that warranty terms may vary by region. Full detailed information is available on our website, here: https://www.zyxel.com/support/warranty_information.shtml
Purchase Information
Zyxel Product Name:
Hardware Serial Number:
Dote of Purchase:
(In certain countries, the warranty will be validated with the seller’s signature and stamp):