ZYXEL GM4100-B0 G.fast 212 MHz VDSL2 Bridge User Guide
- October 30, 2023
- ZYXEL
Table of Contents
ZYXEL GM4100-B0 G.fast 212 MHz VDSL2 Bridge
Hardware Installation
① Use a phone cable to connect the G.fast port to a DSL splitter or directly
to thetelephone wall outlet.
② Connect a computer or Access Point to a LAN port using an Ethernet cable.
③ Use the included power adapter to connect the power socket to an appropriate
power source. Press the ON/OFF button to turn on the Zyxel Device.
④ Check that the LED lights are already on
| Green| Blinking – The Zyxel Device is booting, getting ready for use.
On – The Zyxel Device is ready for use.
---|---|---
Red| Blinking – Firmware upgrade is ongoing.
On – System failure.
| Green| On – G.fast I VDSL 2 I ADSL 2( +) link is up.
Blinking (slow) – Link is down and trying to detect carrier signal.
Blinking (fast) – Initializing the link.
| Green| On – Ethernet is ready.
Blinking – Transmitting/receiving LAN data.
Wall Mounting (Optional)
① (Optional) Drill two holes on the wall at the distance of 80 mm. Insert the
screw anchors and screws (not provided).
2-a Place the Zyxel Device so the wall mount holes line up with the screws.
2- b Slide the Zyxel Device down gently to fix it into place.
Drilling Guide
① Place this Quick Start Guide on the wall and use it to mark the holes for
drilling.
② Use a 6.0-6.5 mm-size drill bit to drill two holes in the wall to a depth of
32 mm.
Support Information
EU
See the User’s Guide at www.zyxel.com for more information, including customer support and safety warnings.
EU Importer
Zyxel Communications A/S Gladsaxevej 378, 2. th. 2860 S0borg, Denmark.
https://www.zyxel.com/dk/da/
Copyright© 2022 Zyxel and/or its affiliates. All Rights Reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>