Whirlpool WFW7590F Front Loading Washer Instruction Manual
- June 17, 2024
- Whirlpool
Table of Contents
Front-Loading Washer
WFW7590F Front Loading Washer
PRODUCT MODEL NUMBERS
WFW7590F, WFW75HEF, WFW90HEF, WFW92HEF
Recessed or closet installation – stacked washer and
dryer
* Add spacing of 1″ (25 mm) on all sides of
washer/dryer.
Recessed area or closet installation (washer
only):
** Recommended 4″ (102 mm),
minimum 1.5″ (38 mm)
Undercounter installation – washer only:
All dimensions show recommended spacing allowed, except
for closet door ventilation openings which are the minimum required.
For each arrangement, consider allowing more space for ease of installation
and servicing, and spacing for companion appliances and clearances for walls,
doors, and floor moldings.
Space must be large enough to allow door to fully open. Add spacing of 1″ (25
mm) on all sides of washer to reduce noise transfer. If a closet door or
louvered door is installed, top and bottom air openings in door are required.
ELECTRICAL REQUIREMENTS
A 120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical supply is
required. A time-delay fuse or circuit breaker is recommended. It is
recommended that a separate circuit serving only this appliance be provided.
DRAIN SYSTEM
Drain system can be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. Select method you need. IMPORTANT: To avoid siphoning, only 4.5″ (114 mm) of drain hose should be inside standpipe. Always secure drain hose with cable tie.
Floor standpipe drain system
Minimum diameter for a
standpipe drain: 2″ (51 mm). Minimum carry-away capacity: 17 gal. (64 L) per
minute. A 1/4″ (6 mm) diameter to 1″ (25 mm) diameter Standpipe Adapter Kit is
available (Part Number 3363920). Top of standpipe must be at least 30″ (762
mm) high; install no higher than 96″ (2.44 m) from bottom of washer. If you
have an overhead sewer and need to pump higher than 96″ (2.44 m), a sump pump
and associated hardware are needed. See “Alternate Parts”.
Wall standpipe drain system
Because Whirlpool
Corporation policy includes a continuous commitment to improve our products,
we reserve the right to change materials and specifications without notice.
Laundry tub drain system
Minimum capacity: 20 gal. (76 L). Top
of laundry tub must be at least 30″ (762 mm) above floor; install no higher
than 96″ (2.44 m) from bottom of washer.
Floor drain system
Floor drain system requires a Siphon
Break Kit (Part Number 285834), 2 Connector Kits (Part Number 285835), and an
Extension Drain Hose (Part Number 285863) that may be purchased separately.
See “Alternate Parts”. Minimum siphon break height: 28″ (710 mm) from bottom
of washer. (Additional hoses may be needed.)
Dimensions are for planning purposes only. For complete details, see
Installation Instructions packed with product. Specifications subject to
change without notice.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>